Stuart Turner Monsoon Extra Standard 4.5 Bar Single Flow Booster Pump 46326
This is a New Old Model Pump that has been stored without its packaging.
A Property kept 2 of these as back up replacements in case their working ones went down.
It is missing the Plastic cover that goes over the impeller fan on the motor end of the pump. This also works as a foot for that end of the pump. It will work fine without this but may need something like a block of wood or pad to support that end of the motor.
If you are replacing like for like you could swap this from the existing pump.
The Pump is mechanically in New condition, spins freely and ready to be installed.
There is some surface marks/tarnishing from storage.
Comes as pictured without any accessories/paperwork.
Installation Manual can be found here:
https://www.showerstoyou.co.uk/uploads/documents/Monsoon_fitting_Instructions_46281-46387-46283-46326.pdf
Largest model they made
Model: Standard 4.5 Bar
Part Number: 46326
Delivery: Parcelforce 24!
To use in larger domestic and light commercial applications.
Specification:
Monsoon Extra standard single flow commercial pump for use with positive head systems. Boosts water pressure to 4.5 bar.
High pressure.
Single flow pump to boost a single water feed, either hot or cold.
Positive head: Suitable for positive head conditions only with a minimum gravity flow of 1.0 litres per minute.
Suitable for open vented hot and cold water systems.
Solid construction.
Quiet operation (from 55db).
Ideal for boosting water pressures to individual outlets where a high pressure is required.
Suitable for large houses, small hotels and leisure facilities where multiple showers are required.
Suitable for boosting the water outlet between the shower valve and multiple shower heads.
Flow switch: Fully automatic. Gravity flow required to start pump.
Flow switch sensitivity: Approx 1.0 Litres per min.
Maximum flow: 45 litres per minute maximum.
Equivalent to raising the cold water cistern 37 metres above its current position.
Pipe connections: 3/4"
Water pressure: 4.5 bar.
Pre wired power cable.
All electrical connections should be carried out by a qualified electrician.
Power consumption: 1060 Watts.
Fuse rating: 13 Amps.
Enclosure BS rating: IPX4.
WRAS approved.