Wurkkos TS32 Powerful  15000LM 3A Power Bank Dual Switch Waterproof Flashlight

Specifications 

Emitter: 12* XPL2 /LH351D+ 1* Luminus SFT40
Reflector: Smooth reflector
Driver: FET circuit(floodlight)+Buck constant current circuit(Spotlight)
Beam angle:spotlight 7°, floodlight 78°
Operating voltage: 2.7V – 4.2V
Battery options: 3* 21700 Li-Ion battery
Dimension: 132.4mm (length) x 62.4mm (head diameter)
Weight: 435 ±1 grams (without battery)
Flashlight body: Aerospace grade 6061 grade aluminum alloy, CNC manufactured to hard-anodized to military grade specification type III, anti-abrasive finish to get solid built body, anti-crash geometry and better heat exchange.
Toughened mineral glass lens
Water resistance i.a.w. IP68
Mode Memory: memorizes the last brightness level used in the general modes (except Strobe)
Reverse polarity protection to protect against improper battery installation.
Advanced Temperature Regulation (ATR) technology: ATR will reduce the brightness level automatically when the driver temperature reaches 55 to prevent overheating.

Power Indicator

TS32 has 4 pieces LED indicator between the two side switches,when on, it will turns off automatically in 32-40 seconds if without any operation.
Remaining battery power shows when Charging:
4 indicator lights on= 100%
3 indicator lights on,1 indicator light flashing=more than 75%
2 indicator lights on,1 indicator light flashing=50%-75%
1 indicator lights on,1 indicator light flashing=25%-50%
1 indicators flashing(0.5hz)=less than 25%

Remaining battery power shows when Reverse Charging:
4 indicator lights on=more than 75%
3 indicator lights on=50%-75%
2 indicator lights on=25%-50%
1 indicator lights on=3%-25%
1 indicators flashing(1hz)=0%-3%

Low Voltage Protection: If the battery’s voltage is lower than 2.7V, TS32 turns off automatically to avoid battery damage by over discharge.

Emitter: 12* XPL2 /LH351D+ 1* Luminus SFT40
Reflector: Smooth reflector
Driver: FET circuit(floodlight)+Buck constant current circuit(Spotlight)
Beam angle:spotlight 7°, floodlight 78°
Operating voltage: 2.7V – 4.2V
Battery options: 3* 21700 Li-Ion battery
Dimension: 132.4mm (length) x 62.4mm (head diameter)
Weight: 435 ±1 grams (without battery)
Flashlight body: Aerospace grade 6061 grade aluminum alloy, CNC manufactured to hard-anodized to military grade specification type III, anti-abrasive finish to get solid built body, anti-crash geometry and better heat exchange.
Toughened mineral glass lens
Water resistance i.a.w. IP68
Mode Memory: memorizes the last brightness level used in the general modes (except Strobe)
Reverse polarity protection to protect against improper battery installation.
Advanced Temperature Regulation (ATR) technology: ATR will reduce the brightness level automatically when the driver temperature reaches 55 to prevent overheating.

Power Indicator

TS32 has 4 pieces LED indicator between the two side switches,when on, it will turns off automatically in 32-40 seconds if without any operation.
Remaining battery power shows when Charging:
4 indicator lights on= 100%
3 indicator lights on,1 indicator light flashing=more than 75%
2 indicator lights on,1 indicator light flashing=50%-75%
1 indicator lights on,1 indicator light flashing=25%-50%
1 indicators flashing(0.5hz)=less than 25%

Remaining battery power shows when Reverse Charging:
4 indicator lights on=more than 75%
3 indicator lights on=50%-75%
2 indicator lights on=25%-50%
1 indicator lights on=3%-25%
1 indicators flashing(1hz)=0%-3%

Low Voltage Protection: If the battery’s voltage is lower than 2.7V, TS32 turns off automatically to avoid battery damage by over discharge.

Operation Instructions

TS32 with dual switches, The upper and lower switches control the
operation of spotlight and floodlight respectively.

Group 1: Stepped modes (default)

Spotlight Modes: Eco(10lm)-Low(100lm)-Mid(350lm)-High(900lm)-Turbo(2000lm)

Floodlight
Modes:Moonlight(1lm)-Eco(30lm)-Low(300lm)-Mid(1000lm)-High(3000lm)-Turbo(14000lm)

Strobe modes(both beam lights on):strobe-SOS-beacon

When both off:

From OFF single click to turn ON. Press and hold to cycle through stepped
modes.

Double click to activate Turbo mode. While in Turbo mode, single click to turn
off.

From OFF, hold 1 second to Eco(spotlight) or Moonlight(floodlight), single
click to turn off,keep press and hold to cycle stepped modes.

Triple click to strobe modes,double click to cycle strobe-SOS-beacon,single
click to turn off.

When on:

Single click to turn off.

Press and hold to cycle through stepped modes.

Double click to activate Turbo mode. While in Turbo mode, single click to
previous mode.

Triple click to strobe modes,double click to cycle strobe-SOS-beacon.another
single click to previous mode.

Group 2: Ramping mode

Spotlight adjust from 10lm to 2000lm;Floodlight adjust from 1lm to 14000lm

Ramping mode gives you full flexibility to adjust brightness steplessly from
Eco/Moonlight to Turbo level.

When off:

From OFF single click to turn ON. Press and hold to change brightness
steplessly (“ramp”). Ramping changes its direction when the button is being
pressed again within 1,5 seconds. The light flashes once when it reaches the
lower or upper end of the ramp.

Double click to activate Turbo level, another single click to turn off.

From OFF, hold 1 second to Eco(spotlight) or Moonlight(floodlight), then press
and keep holding will adjust brightness steplessly.

Triple click to activate Strobe mode, double click to cycle strobe-SOS-beaconanother
single click to turn off.

When on:

Single click to turn off

Press and hold to change brightness steplessly.

Double click to activate Turbo level, another single click to previous modes.

Triple click to strobe modes,double click to cycle strobe-SOS-beacon.another
single click to previous mode.

Toggle between Group 1 and Group 2

When ON Quick quadruple click to change between both mode groups. 3 flashes
will confirm the mode group changed.

Electronic Lockout

TS32 comes with a lockout function to prevent accidental activation, e.g. in
one’s pocket or backpack.

From OFF quadruple click to active lockout. Another quadruple click to deactive
lockout again and return to the previous mode setting. When the light is
locked, the main LED only blinks two times to show the status of being locked.
While in lockout mode, hold the side switch to use Eco mode.


FAQ




    Package Included:

    • 1 x Flash light with full set 







PAYMENT


Only PayPal is Accepted!
IMPORTANT! PLEASE READ! Buyers are responsible  for import duties, custom fees and taxes, if any.  Please check with your country?s custom office to  determine the additional costs impose on the item  prior to buying.
You can leave notees in PayPal when making the  payment if you have any special requests.

sin_ebay_pay



Delivery details


Most the items you purchase will normally be dispatched within 1-2 business days by Hong Kong air mail, China post, or Singapore post which will take 7-21 working days normally to arrive.During different period,we will choose the fastest post office to ship the parcels so that we can not support the post office choice from the dear customers.

The arrival time depends on different areas in the world:



If you choose EMS Express, the shipping fee quoted for EMS Express is only available for the regions shown below:

U.S., U.K., Canada, Australia, New Zealand, Papua New Guinea, Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, Malta, Norway, Portugal, Spain, Sweden, Switzerland, Japan, Korea, Mongolia, Hong Kong, Macau, Cambodia, Indonesia, Malaysia, Philippines, Singapore, Thailand, Vietnam, Bangladesh, India, Laos, Nepal, Pakistan, Sri Lanka, Turkey, Argentina, Brazil, Colombia, Cuba, Guyana, Mexico, Panama, Peru, Russia, Belarus, Ukraine, Czech, Hungary, Poland, Israel, Jordan.

If your region is not listed, please contact us in advance and we will check if the EMS service could be available to your country.

Please make sure to provide your telephone number during check out.



           Return policy

YOUR SATISFACTION IS OUR FIRST PRIORITY!

1, We refund or exchange if the item is damaged or lost.

2, Please contact us before return the goods.



contact us

1.If you have any questions, concerns, welcome to email us. We will try to reply you as soon as possible !

2.Please EMAIL us with any problems before leaving neutral or negative feedback, we will help you solve the problems ASAP. Thanks !




              Thank you