Tape Measure Holder

This holds one Tape Measure at a 10-degree angle and is designed to work with many 25' tape measures, including wide versions (such as Stanley FatMax). The maximum width is 1.9" (49mm) but It also has a notched slot to hold tape measures that are 1.5" (39mm) wide as well. For reference, see photos for a variety of tape measures it can hold. Smaller or skinnier tape measures may not be held well. The sides are mostly open to allow for belt clips to not interfere. There is a vertical slot in the back to hold a pencil or sharpie marker behind the tape measure. The back is designed to be mounted in a variety of ways including screws to the wall, pegboard, and Ryobi Link Wall Rails System.

If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard with 1" (25.4mm) holes, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place more securely.

No tape measures are included and shown in photos for reference only.

It is 3D-printed in PLA plastic. It is 2.3" x 4" x 3.5" (59mm x 103mm x 90mm).

Note: This design replaces an earlier design, which was for wall/pegboard only and tape measures that were only 1.5" (39mm) wide. If you need this earlier version to match others, please let us know and we can reprint it for you.