Iron on only. Shirt not included
RHINESTONE
INSTRUCTIONS:
1.
Preheat iron to cotton setting. Heat
Press 320
2. Put cardboard in between shirt so the
rhinestone glue doesn’t go through to the back of the shirt. OR the
parchment paper sent with this order
3.
Peel off textured backing from the design (stones should stick to the clear
plastic sheet). If any stones have shifted out of place, put them back in place
using tweezers.
4.
Place plastic sheet, stone side down on fabric and press into place with hand.
The clear plastic sheet should stick to the fabric.
5.
Place iron over design area and apply steady pressure for 15 seconds - DO NOT
MOVE IRON AROUND AS STONES MAY SHIFT –
6. Turn Garment WRONG SIDE OUT and Place iron
over design area for another 15 seconds and repeat.
7.
Set aside and allow to cool for 3 to 5 minutes.
8.
Turn fabric to right side out. Slowly and carefully peel the clear plastic
sheet away from the fabric. If all stones are not sticking, you may re-iron on
the opposite side of the fabric again.
*** These hot fix and iron on rhinestones and transfers
are not intended for use by or near small children. Please do not allow
children access to these products.
*****Wear
To Start is NOT responsible for garments for any
reason. Look
over carefully prior to ironing. Make sure the back of the transfer is free of
plastic or debris. Use tweezers to remove any unwanted materials that might
have been missed from the transfer, or to put the rhinestone back in place if
they moved from original location on the carrier.****