3D Black Carbon Fibre Vinyl Wrap Sheet Film Sticker 

  • Texture: PVC Thickness: 0.16mm Range of temperature: -20C to 150°C

  • Test of report: European Environmental Standards Release paper: 140gsm air-free bubbles

  • Durability: 3 to 5 years

  • Main Advantage: •1.Polymeric high flexibility PVC film material,stretchable with heat.

  • Navy Blue carbon fiber vinyl carbon film with 3D effects!

  • Easy to install,will not fade,chip,crack or peel.

  • Easy to be removed from the car body without any damage.

  • Gluce first-class,no damage the car paint.

  • Prevent your car from ourside damage,such as the water,dirt,grease,weak acides,weak base,oil and so on.

  • Cost-effective and can be cleaned with detergent and water

  • Environmental materials: Non-toxic

  • UV protective finish

  • Width: 1.52m


Instructions

  • You will need a heat gun and Squeegeed Cleaning the surface with rubbing alcohol prior to installing the vinyl will help with adhesion and clean any contaminants that may cause imperfections
  • the optimum temperature reached during post-heating is 110-120C.
  • Make sure the vinyl is down securely in any recesses and channels.
  • Check that the vinyl hasn’t lifted in any areas, leaving pockets of air that will cause the film to burn when we apply heat.
  • If the film lifts as the temperature increases, it indicates that there is still air beneath the film. This air will expand, causing the film to lift and burn through.
  • Working on areas 8-10 inches wide, move your heat gun over the vinyl, until the required temperature is achieved. This may take some time, depending on the quality of your heat gun.
  • Repeat this process over all channels and recesses, being sure not to miss any small areas.
  • Then apply the same process to any trimmed edges and areas where the film has been overlapped.
  • Once post-heating has been completed, and you have inspected the vehicle for any imperfections, the vehicle needs to remain on your premises for the next 12-24 hours. This will allow the adhesive to harden, and the facestock to stabilize.