The mini looper pedal's versatility makes it a valuable addition to you guitar board.

The pedal uses a special bypass relay switch that allows you to isolate and bypass effects pedals that are not true bypass and will negatively affects your signal to maintain the original tone of your guitar. That allows you to isolate and bypass effects pedals that are negatively impacting your signal to preserve your guitar's original tone. It also allows you to turn on a group of effects for a certain time briefly.

Use a looper pedal to turn groups of pedals on and off simultaneously, rather than individually.

You can even loop all of your pedals if you want to bypass them all and send your guitar clean signal directly to your amplifier.

The Smart Switch Looper is SEND - RETURN pedal with automatic latching or momentary switching provides silent switched bypass with intelligent functions, microcontroller based. The switch remembers the last mode and turns it on after reconnecting the power, is used soft latch switch without latching and without clicking.

True-bypass pedal circuit board automatically connects your SEND input to GND when bypassed to avoid noise.

Pressing and immediately releasing the footswitch (tap) toggles the relay on or off. Holding down the footswitch will momentary toggle the relay until the footswitch is released.

A latching relay is used for low power consumption. The switch has a built-in two-color LED to indicate the mode.

We use high quality components, relay made in Japan.

Pressing and immediately releasing (tap) footswitch to toggle relay ON or OFF

Hold down the footswitch while the relay is ON to momentarily OFF until the footswitch is released

Hold down the footswitch while the pedal is OFF to momentarily ON until the footswitch is released

Input voltage: 7-18VDC

Standby current: 5 mA

Switch current: 20 mA (momentary)

Hammond 1590A

95 mm X 40 mm X 34 mm

3.62 in X 1.49 in X 1.22 in