Clutch slave cylinder Hymec 57 mm

HYMEC REPLACEMENT CLUTCH SLAVE CYLINDER

• RETRACTED LENGTH: 41mm
• INSTALLATION DIMENSIONS: 56mm to 58mm

If you are the owner of an older HYMEC clutch system and a

If you need a replacement slave cylinder, check the current part number

However, if you are not sure, we have developed a method that will help you

Finding the spare part number easier.

Remove the slave cylinder from the motorcycle and operate it

Master cylinder until the slave cylinder actuating rod is completely

has moved in. The piston in the slave cylinder now touches the bronze cap

at the rear of the slave cylinder. If the slave cylinder

no longer works, it can be removed from the pressure line

and the actuating rod for the measurement slowly and carefully

be pushed into the slave cylinder.

Please note that the measured length is not the actuation length

corresponds - the actuation length is 16 mm longer than the retracted one

Length. After measuring, please dispose of your old slave cylinder

not yet, as you may still need the cap or support.

All MAGURA HYMEC replacement slave cylinders come with a standard cap

and standard support as shown in the pictures.

If the slave cylinder you need is between two actuation lengths

always order the longer version and use it

Spacer between support and Bowden cable attachment to increase the operating length

to adapt to your motorcycle.