Multicrete Products Pattern Imprinted Concrete Sealer - 5 Litres Gloss Finish

A high quality Acrylic solvent based clear sealer, designed to enhance and protect Pattern Imprinted Concrete areas by repelling water, dirt, oil and fuels.

 Benefits

•Ready for use no dilution required

•Surface dry in 1-4 hours (air and ground temperature dependant)

•High Solids

•Enhances imprinted concrete drives and patios.

Application

• For new surfaces – leave up to 7 days after new concrete is laid. Ensure the surface is clean and thoroughly dry.

•For old surfaces – fully clean off with power wash, ensure surface is free of stains and debris. Allow to thoroughly dry prior to application.

•Do not be tempted to power wash in the morning and apply sealant in the same day.

•Can be applied by course droplet low level, chemical resistant sprayer, soft bristled brush or roller. (Do not use plastic coloured brushes)

•Avoid excess pooling and over coating.

•Ensure expansion joints are well cleaned and allow to thoroughly dry.

•Tints can be used but are not recommended unless they have been applied in the past or there is an issue with bare concrete visible.

Coverage

• 2-4 square metres per litre depending on the substrate, porosity of surface and application method. Some porous or neglected surfaces may require more than a single coat.

Test Patch

•Some sealants may impart a glossy, wet look that isn't always to everyone's taste and some products may not be suitable for your particular type of paving. Therefore is always advisable to test the sealant on a small discreet area before applying it to the whole driveway or patio.

Limitations

• Do not apply when ground temperatures are below 5°C

•Do not apply to damp or wet surfaces or if moisture is present

•Do not apply when rain is imminent  or if efflorescence is present

•Do not walk on treated area till dry

•Do not park vehicles on treated surface for 24-48hrs

•Do not use on clay surfaces

•Not recommended for Indian stone, limestone or natural stone.

•Inclusion of additives such as colour tints, pigments and anti-slip agents may affect final finish

Please note - solvent based sealants may "bloom" should damp or moisture be present before cure has taken place. Solvents are released during the cure that normally permeate through the sealer, however if the sealant is applied too thickly, the substrate is damp or cold, blooming may occur giving the appearance of milky white or silvery cloud effect, this may look patchy, spotty in certain areas or across the whole driveway or patio.

If you experience a bloom in your finished sealed surface please understand this is chemical reaction to moisture and although this looks unsightly, this is not a product fault and can be rectified with Xylene or Bloom Remover.