Requires Windows XP, Vista, or 7 (Does NOT work on Windows 8, 8.1, or 10)

This module connects to your computer via a USB cable. Then use the free software to record up to 300 seconds of .wav files to it. The software is very powerful and will allow you to stack wave files and program pauses so the sensor can be used to trigger up to 200 different messages - or a different group of messages each time, up to 100 groups! (The messages or group of messages are played sequentially each time MOTION is detected). Comes with a built-in speaker.

Features:

  • Up to 300 seconds of re-recordable voice message (4.7K sample rate)
  • Includes 6 different playback settings including repeat and continuous playback
  • Motion Detection 3 to 4 feet. 
  • Detection method - Change in light level.
  • Use USB type-B male connector for direct plug into USB cable (not included)
  • Easy to transfer software for windows of .wav audio files
  • Choice of sample rates
  • 300 seconds non-volatile recordable IC.
  • Operating Voltage 4.5V (3 x AA batteries not included)
  • Operating Current < 50 mA
  • Standby Current < 5 uA
  • 55mm built-in speaker (included)

Dimensions: 65 x 94 x 26mm

System Requirements:

  • Type "A" Male to type "B" Male USB cable (One cable per shipment included)
  • Unused USB port on computer
  • Windows XP, Vista, or 7 (Does NOT work on Windows 8, 8.1, or 10)
  • 3 x AA Batteries (Not included)
Troubleshooting:
Additional Details:
 

NOTE: This unit will only record .WAV files. However, you can download a .mp3 file converter here: 

It is a very easy to use. Just open the sound file in this program, and save it as .WAV, and select PCM unsigned, 8 bit, mono in the Attributes section.

IMPORTANT NOTE: Use PWM DIRECT DRIVE in the software for this unit (DO NOT USE DAC for Ext.AMP like for the USB5M).

In Windows Vista/ Win 7 the PM66 software must be run as administrator by right clicking on the PM66 icon ad then click to "Run as administrator" 


NOTE: The sensor will detect to about three feet away. Also, to adjust volume, use GOLDWAVE for a softer or louder recording. Unit does not work well in dim light.

Documentation and Downloads