Dodge RAM 2002-2005 Double Din Aftermarket Dash Kit
Mossy Oak Shadow Grass Blades 3M DI-NOC VINYL
This dash kit comes complete with Bezel, Installation Brackets, Aftermarket Wire Harness and Antenna Adapter.
The bezel is a solid piece of ABS plastic that is wrapped in a genuine Mossy Oak vinyl pattern to give a custom flare to your vehicle's interior design. This bezel is engineered to convert your factory radio opening to house USA Standard Double Din Aftermarket Radios that measure 180mm x 100mm.
The wire harness is designed to prevent the mess of cutting and splicing wires. As it does meet EIA color codes just match the colors up from this harness with the harness that was provide with your aftermarket radio. Please note that this wire harness is not compatible with Infinity Amplified System.
The antenna adapter is used to adapt the factory antenna end to the standard Motorola male end needed to plug in to your new aftermarket radio.
Other Mossy Oak Patterns Available:
Blaze, Bottom Land, Break-Up, Break-Up Infinity, Brush, Duck Blind, Obsession, Pink Bottom Land, Pink Break-Up, Shadow Grass Blades, Tree Stand, Winter and Winterbrush. Any other pattern can be ordered by request with a 10 to 15 day shipping delay. Please email for more details.
You will have some work to do for the installation.
Basic Installation Directions
1- Disconnect the negative battery terminal to prevent an accidental short circuit.
2- Unclip the top edge of the trim panel below the steering column (it does not have to be removed)
3- Remove the one Phillips head screw from below the right A/C vent.
4- Unclip and remove the dash trim panel
5- Remove the 4 Phillips screws that secure the radio. Disconnect and remove the radio.
6- Remove the 4 Phillips screws that secure the a/c controller (save these screws they will be reused).
7- Remove the 4 Phillips screws that secure the factory pocket (save these screws they will be reused).
8- Locate the 11-PVC welds. With a drill with a 1/4 drill bit, drill each PVC weld out (you can drill right through the old face plate)
9- Next secure the supplied double din brackets to the new radio bezel using supplied screws.
10- Mount the aftermarket radio to the brackets. Adjust the depth of the radio until it sits perfectly flush with the front bezel face.
11- Reinstall the factory pocket and a/c unit using the factory screws.
12- Wire the aftermarket radio harness to the install harness supplied.
13- Plug in aftermarket radio harness to aftermarket radio & install harness to factory radio plug.
14- Connect antenna adapter to factory antenna end & aftermarket radio.
15- Plug in a/c harness.
16- Snap main dash bezel back into the dash.
17- Install screw to retain the dash.
18- Reconnect the negative battery terminal.