VXD Chrome Badge & Keyring Set with Black Detail
The badges are chrome finished ABS plastic
with painted detail, adhesive backing and includes surface preparation wipes.
The universal grill mount includes a badge mounting plate, two bolts and a
retaining plate. The keyring is solid metal with flexible double link and
strong flat loop.
Dimensions:
Each badge is 85x30mm
Please read these
instructions carefully before installing. Failing to do so may result in
the badge failing to bond as intended.
Good surface
preparation is the key to a successful installation. Ensuring that the
surface is properly prepared is the responsibility of the installer.
To install the grill
badge, the mount needs to first be attached to your grill. Insert the two
screws into the mount and thread them through the grill. Next put the backing plate on the bolts and
tighten the two nuts to secure in place. The badge is now ready to apply to the
mount.
Ensure surface is
free from road dirt and is completely dry. We suggest applying a badge
when the temperature is above 15°C,
if the temperature is lower, you can gently heat the surface from a distance
using a hair dryer.
Using a circular
motion, thoroughly clean the surface with the enclosed surface
preparation wipe for about 20 seconds, you may see the remaining dirt which was
on the panel transfer onto the wipe.
If the surface has
had waxes or silicon based products applied, further preparation will be
required, we recommend using "spirit wipe" (not white spirit, this
will make the surface greasy) or 99.9% isopropyl alcohol. If
there are traces of wax or silicon between the badge and surface, it will not
fully bond.
Wait about 1 minute or until the solvent has fully evaporated and the
surface is dry.
Remove the wax film from the back of the badge, position it onto the
surface and firmly press all over for 10 seconds.