*PLEASE NOTE THAT HANSGROHE USE TWO SIZED TAP TAILS. SOME 1/2" AND SOME 3/8" THESE ARE FOR THE 1/2" VERSION*

An easy way to test which size you have is to see if a 5p piece fits inside the nut at the end of the flexible tail. If the 5p fits, you should have a 1/2" BSP. If the 5p doesn't fit you should have 3/8" BSP.

Used for most popular European monobloc taps that come supplied with a 1/2" female thread as opposed to the smaller 3/8"

Do not be caught out, most people/plumbers automatically assume that the tap will be supplied with tails that connect straight to copper. By the time they have found out that it is a spinning nut it is usually too late! Be prepared.

These fittings will convert your 1/2" female fitting so that it is able to take standard 15mm copper or plastic pipe. Simple push fit fitting allows for easy installation.

You will receive 2x plastic pushfit fittings. The flexis in the pictures are purely for descriptional purposes.

Please make sure you are pushing fittings onto bare, clean copper or plastic with no burrs or splinters. Failing to do so could potentially split the o'ring seal inside the fitting

1/2" is BSP measurement. If you were measuring the thread on these fittings on a tape measure they would measure 20mm