Good sliding properties (SEE GRAPH BELOW)
Strong and rigid
Resistant to amny oils, greases, diesel, petrol and cleaning fluids
Increased surface hardness
Weathering resistant
COME WITH ALL FASTENERS REQUIRED
THE FRAME MUSHROOMS ARE MADE FROM HIGH DENSITY ACETAL AND COME COMPLETE WITH M10 X 1.25 DE-EMBRITTLED (WILL NOT SNAP ONLY BEND) FINE PITCH BOLT. NOT CHEAP RUBBISH AS MANY OTHER PEOPLE SELL ON EBAY.
SIZE OF THE MUSHROOM ACETAL 50mm DIAMETER X 95mm max.
This set of sliders will fit on a gsxr 600 / 750 sportsbike. This kit bolts on, needing modifications to Left hand fairing . These sliders bolt into the upper engine mount, replacing the existing bolts.
Installation Instructions:
Remove your RHD fairings, and find the engine mount locations where the sliders fit.
They are made for a specific location. They will only fit in one place, remove the m10 engine mounting bolt
Insert m10 bolt supplied through the shorter bobbin with the washer behind the bolt head.
Insert the assembly into engine mount recess.
Tighten up until you feel compression, and then tighten and do not exceed 40 nm of torque.
Remove your RHD fairings, and find the engine mount locations where the sliders fit.
Remove m10 engine mount bolt and paint end.
Replace fairing into original position so the painted bolt leaves a mark on the inside of the fairing.
Drill a small hole in the marked position on the fairing and check it is in the correct position.
Then carefully drill out the fairing with a 25mm tank cutter or similar
Replace fairing
Insert m10 bolt and washer in the longer mushroom and tighten as above.
Colour: Black
Parts supplied:
2 x crash mushrooms (HIGH DENSITY ACETAL) WITH PLASTIC END CAPS
2 x HIGH TENSILE m10 steel bolts (HEX key type)
2 x M10 WASHERS AND 2 X SHAKEPROOF WASHER
WILL FIT THE FOLLOWING MODELS