The components The variants The video The build guide

Copper sheets

Made in Spain by MART&GON
Perfectly cut and curved with rounded and straightened edges on the outside as well as on the hole for the 510er
Dimples on the battery contact surfaces

Liquid bottle

Made by Mod Maker in England
It comes with a soft thin wall bottle, a stainless steel knurled cap, a silicone tubing and a silicone washer. The bottle holds 8.5ml of juice. The washer probably won't be need but it is included in case your lid doesn't seal 100% with the bottle.
To insert the hose simply cut the end at a 45 degree angle and twist through the hole. It is a reasonably tight fit and provides a very good seal.

510 Bottom Feeder Connector

Made by Mod Maker in England
Glass filled peek insulator. This material can take some serious heat. Wave spring. A stiffer spring for a better connection. Oring / gasket. Embedded into the positive pin to reduce leakage. Negative solder tab. For non mechanical squonkers.
The threaded section is m12 (12mm x 1mm) thread. The top plate is 16mm diameter and 0.5mm thick. When you add a washer, the top plate will be 1mm thick.

Magnets

Battery strap

Microfiber cloth

From Coil Master from the US. Ideal for cleaning the Squonker (but also suitable for spectacles)

Build Kit complete:

Two copper sheets for the connection of the battery and the 510 connector via the power button and for the connection back from 510 connector to the battery.
Mod Maker 510 Bottom Feeder connector and a washer with 22mm diameter.
Mod Maker Squonker Bottle Kit, capacity 8.5 ml.
Two neodymium magnets 5 x 1 mm (width/height).
Satin battery strap 6.5 cm.
Coil Master microfiber cloth 15 x 15 cm.

Copper sheets only:

Two copper sheets for the connection of the battery and the 510 connector via the power button and for the connection back from 510 connector to the battery.

510 connector only:

Squonker bottle only:

Magnets only:

Not sure if you already checked out the ATTENTION notes on Shapeways.com but there are some small things to pay attention for:

scrap out the rest of powder especially below the bottom plate of the bottle and the slot of the battery strap
evtl. widen the holes of the button and 510 to get a proper fit
to get the battery strap sit tight burn down one end with a lighter until it stuck in the hole
don't bend the positive battery to full 90 degrees to get a proper tension on the button
to fix the button use a thin piece of adhesive tape

Depending on what 510 (MM510) you are using it is helpful to follow the steps below for assembling

install the positive battery plate
install the negative battery plate without tighten the 510
install a battery to get the final plate position
install the button by lifting the positive battery plate
!!! REMOVE BATTERY
if you want to use 8,5ml bottle you'll have to shorten the 510 Pin
tighten the 510 and the negative battery plate and you're good to go (try to fix the nut and then tighten the 510 with an old Atty instead of trying to tighten the nut)