Schneider Electric (Xantrex) C12, 12Amp 12V Solar Charge Controller
Schneider Electric/Xantrex C12 Charge Controller 12 Amps

    The C12's field configurability and feature packed design makes it the only small PV controller you need!

    Photovoltaic Charge Controller

    • Silent, solid state, series pulse width modulated (PWM) charge control with 3-stage (bulk, absorb, & float).
    • Field adjustable setpoints with removable knobs to reduce tampering (bulk range: 13.0 to 17.0 VDC).
    • Electronic short circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Automatic reset of overload protection system--eliminates problems of tripped breakers and blown fuses.
    • High efficiency, "No diode" design without electronics in the negative conductors (as per NEC code).
    • Optional plug-in/replaceable temperature compensation sensor --ideal for sealed batteries.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Designed for 15 amps of short-circuit PV array current (typically about four 50 watt modules).
    • Two stage lightning and surge suppression through both active and passive protection components.
    • Equalize mode (@ bulk+1DC for 2 hours) with automatic activation every 30 days or if LVD is reached (defeatable).


    DC Load Controller


    • Automatic low voltage disconnect (LVD) with adjustable setpoint (LVD range 10.5 to 12.5 VDC).
    • Automatic low voltage reconnect (LVR) with adjustable setpoint (LVR range 12.0 to 14.0 VDC)
    • Selectable automatic or manuals reconnection of loads after low voltage disconnect accurs.
    • Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Low voltage disconnect warning system--blinks loads on-off-on when the battery voltage is below the low voltage disconnect setting after a two minute delay. Loads are then disconnected after a 5 minute additional time delay unless loads have been reduced and voltage has risen above the low voltage disconnect setpoint.
    • Manual reset switch on bottom of enclosure allows one-time 10 minute grace period for operation of DC loads after reset has accurred. Additional pushes have no effect until voltage reaches the low voltage reconnect setting.

    Automatic Lighting Controller

    • Automatic control of lighting systems with nighttime detection by using the PV array as a photocell.
    • Adjustable run duration from 2 to 8 hours or "dusk to dawn" all night operation of lights, unless LVD is reached.
    • Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Manual reset switch on bottom of enclosure allows testing of lights during daytime or after LVD has accured.

    Applications:

    • Village Power
    • Cabin/Vacation Homes
    • Outdoor Area Lighting
    • Sign Lighting
    • Bus Shelters
    • Telecommunication.

    Size:

    • 605" H x 4.3" W x 1.5" D
    • 16.5 cm x 11 cm x 4 cm
Hurricane Wind Power
2019
Corporate America Today
2019 Best Off-Grid 
Renewable Energy 
Product Supplier - USA
UP TO 50% DISCOUNTS
TOP BRANDS
Payment
Shipping
Returns

 

We accept payment by any of the following methods:

 

PayPal

 

Please pay as soon as possible after winning an auction, as that will allow us to post your item to you sooner!


We offer Fast shipping on all orders!


Your order will be dispatched within 1-3 working day of receiving payment (Monday-Friday) and you should expect to receive it one or two days after dispatch (for orders sent RM 1st Class).


In the very unlikely event that your item is lost or damaged during post, then WE are responsible and will issue either a full refund or replacement.

 

If you are not 100% satisfied with your purchase, you can return the product and get a full refund or exchange the product for another one, be it similar or not.

 

You can return a product for up to 14 days from the date you purchased it.

Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt.

See our other items

Thank you for visiting our Ebay store!
Schneider Electric/Xantrex C12 Charge Controller 12 Amps The C12's field configurability and feature packed design makes it the only small PV controller you need! Photovoltaic Charge Controller --- Silent, solid state, series pulse width modulated (PWM) charge control with 3-stage (bulk, absorb, & float). --- Field adjustable setpoints with removable knobs to reduce tampering (bulk range: 13.0 to 17.0 VDC). --- Electronic short circuit, overload, overtemperature and reverse polarity protection improves reliability. --- Automatic reset of overload protection system--eliminates problems of tripped breakers and blown fuses. --- High efficiency, "No diode" design without electronics in the negative conductors (as per NEC code). --- Optional plug-in/replaceable temperature compensation sensor --ideal for sealed batteries. --- Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments. --- Designed for 15 amps of short-circuit PV array current (typically about four 50 watt modules). --- Two stage lightning and surge suppression through both active and passive protection components. --- Equalize mode (@ bulk+1DC for 2 hours) with automatic activation every 30 days or if LVD is reached (defeatable). DC Load Controller --- Automatic low voltage disconnect (LVD) with adjustable setpoint (LVD range 10.5 to 12.5 VDC). --- Automatic low voltage reconnect (LVR) with adjustable setpoint (LVR range 12.0 to 14.0 VDC) --- Selectable automatic or manuals reconnection of loads after low voltage disconnect accurs. --- Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability. --- Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments. --- Low voltage disconnect warning system--blinks loads on-off-on when the battery voltage is below the low voltage disconnect setting after a two minute delay. Loads are then disconnected after a 5 minute additional time delay unless loads have been reduced and voltage has risen above the low voltage disconnect setpoint. --- Manual reset switch on bottom of enclosure allows one-time 10 minute grace period for operation of DC loads after reset has accurred. Additional pushes have no effect until voltage reaches the low voltage reconnect setting. Automatic Lighting Controller --- Automatic control of lighting systems with nighttime detection by using the PV array as a photocell. --- Adjustable run duration from 2 to 8 hours or "dusk to dawn" all night operation of lights, unless LVD is reached. --- Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability. --- Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments. --- Manual reset switch on bottom of enclosure allows testing of lights during daytime or after LVD has accured. Applications: --- Village Power --- Cabin/Vacation Homes --- Outdoor Area Lighting --- Sign Lighting --- Bus Shelters --- Telecommunication. Size: --- 605" H x 4.3" W x 1.5" D --- 16.5 cm x 11 cm x 4 cm
Schneider Electric (Xantrex) C12, 12Amp 12V Solar Charge Controller
Schneider Electric/Xantrex C12 Charge Controller 12 Amps

    The C12's field configurability and feature packed design makes it the only small PV controller you need!

    Photovoltaic Charge Controller

    • Silent, solid state, series pulse width modulated (PWM) charge control with 3-stage (bulk, absorb, & float).
    • Field adjustable setpoints with removable knobs to reduce tampering (bulk range: 13.0 to 17.0 VDC).
    • Electronic short circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Automatic reset of overload protection system--eliminates problems of tripped breakers and blown fuses.
    • High efficiency, "No diode" design without electronics in the negative conductors (as per NEC code).
    • Optional plug-in/replaceable temperature compensation sensor --ideal for sealed batteries.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Designed for 15 amps of short-circuit PV array current (typically about four 50 watt modules).
    • Two stage lightning and surge suppression through both active and passive protection components.
    • Equalize mode (@ bulk+1DC for 2 hours) with automatic activation every 30 days or if LVD is reached (defeatable).


    DC Load Controller


    • Automatic low voltage disconnect (LVD) with adjustable setpoint (LVD range 10.5 to 12.5 VDC).
    • Automatic low voltage reconnect (LVR) with adjustable setpoint (LVR range 12.0 to 14.0 VDC)
    • Selectable automatic or manuals reconnection of loads after low voltage disconnect accurs.
    • Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Low voltage disconnect warning system--blinks loads on-off-on when the battery voltage is below the low voltage disconnect setting after a two minute delay. Loads are then disconnected after a 5 minute additional time delay unless loads have been reduced and voltage has risen above the low voltage disconnect setpoint.
    • Manual reset switch on bottom of enclosure allows one-time 10 minute grace period for operation of DC loads after reset has accurred. Additional pushes have no effect until voltage reaches the low voltage reconnect setting.

    Automatic Lighting Controller

    • Automatic control of lighting systems with nighttime detection by using the PV array as a photocell.
    • Adjustable run duration from 2 to 8 hours or "dusk to dawn" all night operation of lights, unless LVD is reached.
    • Electronic short-circuit, overload, overtemperature and reverse polarity protection improves reliability.
    • Continous rating of 12 amps @ 113°F /45°C and 8 amps @ 150°F/65°C for severe environments.
    • Manual reset switch on bottom of enclosure allows testing of lights during daytime or after LVD has accured.

    Applications:

    • Village Power
    • Cabin/Vacation Homes
    • Outdoor Area Lighting
    • Sign Lighting
    • Bus Shelters
    • Telecommunication.

    Size:

    • 605" H x 4.3" W x 1.5" D
    • 16.5 cm x 11 cm x 4 cm
Hurricane Wind Power
2019
Corporate America Today
2019 Best Off-Grid 
Renewable Energy 
Product Supplier - USA
UP TO 50% DISCOUNTS
TOP BRANDS

See our other items

 

We accept payment by any of the following methods:

 

PayPal

 

Please pay as soon as possible after winning an auction, as that will allow us to post your item to you sooner!


We offer Fast shipping on all orders!


Your order will be dispatched within 1-3 working day of receiving payment (Monday-Friday) and you should expect to receive it one or two days after dispatch (for orders sent RM 1st Class).


In the very unlikely event that your item is lost or damaged during post, then WE are responsible and will issue either a full refund or replacement.

 

If you are not 100% satisfied with your purchase, you can return the product and get a full refund or exchange the product for another one, be it similar or not.

 

You can return a product for up to 14 days from the date you purchased it.

Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt.

Thank you for visiting our Ebay store!