16 Pin OBD2 - DB9 Adapter Cable OBDII approx 1M / 100CM - UK Stock
Ideal for Arduino CAN bus interface, or other OBDII Projects
Suitable for EF02037 Arduino CAN Shield
See Pinout at bottom of listing.
Arduino EF02037 compatible CAN Bus Shield HERE
Features:
Could This Connector Be Used on My Vehicle?
- This adapter cable is compatible with all OBD II compliant vehicles. All 1996 and newer vehicles (cars and light trucks) sold in the United States must be OBD II compliant and this includes all domestic, Asian and European vehicles.
- A few of 1994 and 1995 model year gasoline vehicles are OBD II compliant. Please check the Vehicle Emissions Control Information (VECI) Label which is located under the hood or by the radiator of most vehicles. If the vehicle is OBD II compliant, the label will designate 'OBD II Certified'. Additionally, Government regulations mandate that all OBD II compliant vehicles must have a 16-pin Data Link Connector (DLC).
- If your vehicle is OBD II compliant, it must have a 16-pin DLC under the dashboard, and the Vehicle Emission Control Information Label located on the inside of the hood on most vehicles must state that the vehicle is OBD II compliant.
Technical Specification:
| OBD II 16 Pin Connector | DB9 Connector |
| Battery Power 16 | 9 |
| Chassis Ground 4 | 2 |
| Signal Ground 5 | 1 |
| CAN High J-2284 6 | 3 |
| CAN Low J-2284 14 | 5 |
| ISO 9141-2 K Line 7 | 4 |
| ISO 9141-2 L Line 15 | 8 |
| J2850 BUS- 10 | 6 |
| J2850 BUS+ 2 | 7 |
Picture is for illustration purposes only, actual design may vary slightly.
- 100% BRAND NEW!
- High quality OBD2 16Pin to DB9 Cable
- Use for connecting your diagnostic interface and your vehicle
- Compatible with any OBD ll compliant car or van
- Cable length: Approx 100cm
- OBDII plug: 16-pin male to car
- 9-pin female to your diagnostic interface
-
Note: Please note that this is an ADAPTER CABLE not an interface cable.
It should not be attached directly to your laptop
Use this with a CAN Bus adapter or similar board
