Wireless Solar Powered Outdoor Alarm System supplied with:
This is an example of how you can use both the Solar PIR's (900 or 600 metre models) together with any of the Solar Perimeter Beams (1B, 2B or 3B) to make an Outdoor Alarm System to suit your requirements.
You can also add may other accessories to the system (see list below).
Wireless Transmission Range:
The range between the 1B Beams to the Indoor Receiver is an impressive 900 metres (line of sight) which equates to around 400 - 600 metres in most applications, the range between the PIR and Receiver is 600 metres (line of sight) which equates to around 200 - 400 metres in most applications.
These distances can be doubled by adding a Signal Repeater (004-2910).
Receiver:
The Indoor 4 - Channel Wireless Receiver is powered by a standard 3-pin Plug in Transformer and has the following features:
1B Beams:
These impressive Solar Powered Wireless Perimeter Beams are packed with impressive features (listed below) and work in conjunction with either of the Wireless Receivers (indoor 004-2790, 004-2880 & (solar outdoor 004-2810), perfect for protecting the outside of homes, farms & businesses:
The Dual Detection Technology works by having a pair of Detectors (set 60 mm apart from each other) on each Beam, both Detectors have to be breached simultaneously to create an activation, allowing small animals, insects, leaves & debris to safely pass by. There are a pair of detectors on each size of Beam, so these 1B-100 have one pair of detectors, a 2B-100 would have two pairs and the 3B-100 would have three pairs, each pair of detectors work independently of each other resulting in the 3B-100 Beams having three chances to detect an Intruder.
The External Beams are also supplied with an additional Charging Port which can be used to give the Beams a boost charge should you experience a lengthy duration of low sun light, or perhaps one of the beams needs to be fitted into a slightly covered location.
They are very easy to install as they have a built in Red Glow Light (for easy lining up).
You can use up to 128 sets of Beams & PIR's with the Internal Receiver & 32 sets with the Solar Wireless Siren, you can mix & match by using a selection of different sizes of Beams within one single system.
Wireless PIR:
The Detection range of the PIR is 15 metres (which can be reduced by choosing one of the other three sensitivity settings) and the detection width is approximately 15 degrees but with a narrow depth.
By fitting the PIR about 1 - 1.5 metres from the ground, it is possible to avoid detecting small ground animals (providing you mount the PIR horizontal to the ground).
It is powered by a built in Battery which is charged and maintained by the top mounted Solar Panel, there is also an additional charging port in the back of the PIR for applications where the PIR may need the occasional boost charge (shady areas etc).
The PIR is supplied with an easy to mount wall bracket.
The PIR is a nice and compact size measuring 100 (w) x 90 (h) x 140 (d) mm making it easy to hide away in the installation.
Remote Controls:
The two Remote Controls supplied allow you to pause the Receiver for 5 minutes (designed to let you leave or enter the premised when there are Sirens or Auto-Diallers connected to the system).
Additional Accessories:
You can add many additional accessories to this Driveway Alarm System building it to your specific applications, the wide range of options include the following, but there are many more:
Kit Includes:
Receiver:
Wireless PIR:
1B Beams: