KUDACAT 4-Channel Cat 6 / EtherCon Audio Snake Tx & Rx Modules

The KudaCat is a 4-channel audio snake that allows you to send analogue audio signals over standard Cat 5 / Ethercon shielded twisted pair cable

- KudaCat uses four 0.75m Van Damme XKE Ultra Flexible cables with all black Neutrik XLR connectors

- Compatible with AES / EBU Signals

- Carries four analogue lines down a single shielded CAT6 / Ethercon cable

- Compatible with 48 volt phantom power

KudaCat acts like a typical four-channel analogue audio snake. It allows you to send mic or line-level signals from one location to another without signal loss, noise, or interference, and without any digital audio conversion needed.

Utilizing Cat 5 or Cat 6 Ethernet cable, which is widely available, lightweight, and economical, simply connect a shielded Cat 5 / Ethercon cable between any two KudaCat modules and they will use the analogue conductors in the cable to deliver four balanced audio lines to any destination.

KudaCat Rx / Tx units require no power to operate, and since they keep the signal in the analogue realm, no digital conversion is necessary. Straight-wire connection from the XLRs to the RJ45 connector on a Cat 5 / Ethercon cable ensures that your audio passes through without coloration or distortion.

KudaCat is manufactured to order from industry standard Neutrik connectors. Each unit is built to last.

*Models shown use TOP connectors. These are available on request only.