KAWASAKI  ZX1400 & ZX14R CRASH PROTECTORS MUSHROOMS 

 THIS IS FOR A SET OF 8 

BRAND NEW 4 PAIRS OF  CRASH MUSHROOMS PRECISION MACHINED FROM HIGH DENSITY ACETAL SPECIFICALLY DESIGNED FOR CRASH MUSHROOMS:-

• Good sliding properties
• Strong and rigid
• Resistant to amny oils, greases, diesel, petrol and cleaning fluids
• Increased surface hardness
• Weathering resistant

 FRONT AXLE SPINDLE MUSHROOMS

THE FRONT MUSHROOMS MEASURE 45MM DIAMETER AND 48 MM IN LENGTH, MUCH LONGER THAN MANY EBAY SELLERS, WHICH OBVIOUSLY GIVES YOU EXTRA PROTECTION !

THEY ALSO FIT SIZE FOR SIZE IN THE SPINDLE BORE SO WILL NOT FLOAT ABOUT IN THE EVENT OF A SPILL UN-LIKE MANY EBAY SELLERS OFFER!!

VERY SIMPLE TO FIT, JUST CUT THREADED BAR TO DESIRED LENGTH

WHATS INCLUDED:-

• 2 ACETAL CRASH MUSHROOMS FITS FRONT AXLE
• 2 M8 FLANGED NYLOC NUTS
• 1 M8 THREAD BAR
• 2 PLASTIC END CAPS
• FITTING INSTRUCTIONS

REAR SWING CRASH MUSHROOMS / PADDOCK STAND BOBBINS

THE REAR SET FIT ON TO THE SWING ARM MOUNTS AND MEASURE 50MM IN LEGTH, THESE ALSO DOUBLE UP AS PADDOCK STAND BOBBINS

WHATS INCLUDED:-

• 2 ACETAL CRASH MUSHROOMS / PADDOCK STAND BOBBINS FITS REAR SWING ARM
• 2 M10 X 1.25 FINE PITCH BOLTS
• 2 END CAPS

 FRAME MOUNTED CRASH MUSHROOMS

• THE  FRAME MUSHROOMS ARE MADE  FROM HIGH DENSITY ACETAL AND ALUMINIUM COMPLETE WITH M10 X 1.25 FINE PITCH BOLT.

  
  

NO FAIRING MODIFICATIONS ARE REQUIRED TO MOUNT THESE MUSHROOMS.

Installation Instructions: Find the engine mount locations where the mushrooms fit. Remove one engine mount bolt, and replace it with the slider, and provided bolt. Remove the other engine mount bolt, and replace with the other slider and provided bolt. It's just that easy. The torque on the slider bolts should not exceed 20-25 foot-pounds, with locktite on the threads.

WHATS INCLUDED:-

• 2  FRAME  MOUNTED HIGH DENSITY MUSHROOMS
• 2 ALUMINIUM SPACERS TO LOCATE IN FRAME
• 2 M10 X 1.25 PITCH BOLTS 
• 2 M10 WASHERS
• 2 END CAPS
• FITTING INSTRUCTIONS

•  

  ---

   

• EXHAUST HANGER MOUNTED CRASH MUSHROOMS

   

  WHATS INCLUDED:- 
  

  • 2  REAR HANGER MOUNTED  MUSHROOMS
  • 2 ALUMINIUM SPACERS 
  • 2 M10 X 1.5 PITCH BOLTS
  • 2 M10 PLAIN WASHERS
  • 2 SHAKEPROOF WASHERS
  • 2 M10 FLANGED NYLOC NUTS
  • FULL FITTING INSTRUCTIONS

• THE  EXHAUST  MUSHROOMS ARE MADE  FROM HIGH DENSITY ACETAL AND 2311 ALUMINIUM COMPLETE WITH M10 X 1.5 BOLTS AND FLANGED NYLOC NUTS, AND ARE 45MM DIAMETER, AND 117MM TOTAL LENGTH.

• AVAILABLE IN BLACK OR WHITE ONLY , BLACK SENT AS DEFAULT. PLEASE ADD NOTE AT CHECKOUT IF WHITE ITEMS ARE REQUIRED.

THEY WILL FIT THE FOLLOWING MODELS:-

ZZR1400 upto 2011 model

ZX14R     upto 2011 model