Beitian BN-880 GPS Module with Digital compass

This high quality GPS module incorporates a digital compass. 

The best GPS module for INAV.


Please note that this module does not include flash memory - this means that it is configured to the correct mode each time by the flight controller. Just select a baud rate and Ublox in iNav and it will be automatically configured.

The GPS module is configured to run at a baud rate of 9600 and ships for use with Pixhawk and APM (you might need to modify the cable to fit your autopilot board).

GPS receivers are very susceptible to noise, so ensure they are placed as far away from noisey electronics.


Resources:

Google YouTube 'Easy Ardupilot on Omnibus Series: 2. Connecting the pieces and basic setup'

Can be installed as an upgrade on CX-20, Quanum Nova or other quadcopters - Google 'cx-20 Bn 880 gps upgrade step by step'


Features:

Receiving Format : GPS, GLONASS, Galileo, BeiDou, QZSS and SBAS
Positioning Time : Cold Start avg 26s
Warm Start avg 25s
Hot Start avg 3s
Level Positioning Precision : 2m At Open Wind
Output Frequency : 1Hz-10Hz, Default 1Hz
Speed Precision : 0.1 m/s (Without Aid)
Acceleration Precision : 0.1 m/s (Without Aid)
Dynamic Characteristics : Max Height:18000m
Max Speed : 5153m/s
Max Acceleration : 4G
UART Interface : UART Port: TXDA and RXDA
Support Rate : 9600bps
Working Temperature :-40℃ +-85℃
Storage Temperature :-40℃ +-85℃
Power Supply : DC 2.8V-6.0V, Typical: 3.3V or 5.0V
Consumption : Capture 50mA@5V
Size : 28mm x 28mm x 11mm
Weight : 11g

Pinout:

Black : GND Ground

Red : VCC System main power supply voltage is +5V DC

Green: RxDA UART interface - To flight controller Tx

White : TxDA UART interface - To flight controller Rx

Grey : SCL - To flight controller SCL

Yellow : SDA - To flight controller SDA

Please note: Sometimes it may help swapping the Tx & Rx cables around.


Package includes: (Please note, either the 5-pin or the 6-pin connector may be attached)

1x BN-880 GPS module

1x APM JST-PH1.25 5-pin connector

1x Pixhawk JST-PH1.25 6-pin connector

1x Double sided sticky pad


Important Note:

    Our goal is to achieve 5-star rating for each transaction.

    If you are not 100% satisfied, PLEASE do not leave a neutral or negative feedback but contact us by eBay message or email first so that we can help you.

 

Postage

All of our products are stocked at our London premises therefore there are no delays in posting.
We will dispatch all orders the same day if the order has been placed before 3:00pm Monday - Friday (excluding public holidays).
All orders are processed by third party dispatching software and therefore eBay's confirmation dispatch email may be delayed. 
Orders dispatched via Royal Mail may be upgraded to Signed-For or Tracked service at our discretion. 
Average delivery times for Royal Mail are 1-3 days for 1st/24 and 3-5 days for 2nd/48.
Only Royal Mail's Special Delivery service is guaranteed next working day (Mon-Fri) service. 
Most items which are not received are caused by incomplete addresses such as no door number, or incorrect street name or postcode.

Payment

Payment is via eBay's checkout facility.
Once payment has been same, requests for change of delivery address will not be accepted due to eBay's Buyer Protection Scheme. 
Orders must be cancelled and reordered with the correct delivery address.
 
Warranty
If you have simply changed your mind or no longer require the item(s), you must notify us within 30 days from receiving your order. 
The item(s) must be in their original unused and unopened packaging and be in a resalable condition for a full refund. 
You will need to pay for the cost of returning the item(s) and the item(s) remain your responsibility until we receive them.
Damaged caused during transit must be notified within two days of the delivery.

All items sold as tested are genuinely tested before dispatch.
Product(s) which show obvious signs of misuse, damage or weather damage will not be eligible for refund or replacement.
All items are security marked. 
Please ensure all security markings and stickers are intact or any warranty offered will be void.
All items are subject to satisfactory inspection of the anti-tamper warranty sticker/seal.
Any evidence that these aforementioned stickers/seals have been removed or broken will render the item out of warranty and will not be covered under warranty rules. 
If the item becomes faulty within that period a replacement will be issued free of charge upon receipt of the faulty item, back to us, if proved to be faulty upon inspection. 
If the item is not faulty or can be repaired, not to the detriment of the item, then this shall be undertaken rather than direct replacement. 

Warranty Exclusion: Please note that as batteries are "consumables" we only provide dead on arrival warranty. 
The maximum capacity of all rechargeable batteries fades with time depending on application and usage patterns. 
This is considered normal - therefore, a change in battery capacity is not covered under warranty. 
Battery life is not warranted and will vary depending on usage.

Please note- Any software is not covered by the warranty policy. Please refer to the copyright owner for specific details.