This high quality GPS module incorporates a digital compass.
The best GPS module for INAV.
Please note that this module does not include flash memory - this means that it is configured to the correct mode each time by the flight controller. Just select a baud rate and Ublox in iNav and it will be automatically configured.
The GPS module is configured to run at a baud rate of 9600 and ships for use with Pixhawk and APM (you might need to modify the cable to fit your autopilot board).
GPS receivers are very susceptible to noise, so ensure they are placed as far away from noisey electronics.
Resources:
Google YouTube 'Easy Ardupilot on Omnibus Series: 2. Connecting the pieces and basic setup'
Can be installed as an upgrade on CX-20, Quanum Nova or other quadcopters - Google 'cx-20 Bn 880 gps upgrade step by step'
Features:
Pinout:
Black : GND Ground
Red : VCC System main power supply voltage is +5V DC
Green: RxDA UART interface - To flight controller Tx
White : TxDA UART interface - To flight controller Rx
Grey : SCL - To flight controller SCL
Yellow : SDA - To flight controller SDA
Please note: Sometimes it may help swapping the Tx & Rx cables around.
1x BN-880 GPS module
1x APM JST-PH1.25 5-pin connector
1x Pixhawk JST-PH1.25 6-pin connector
1x Double sided sticky pad
Important Note:
Our goal is to achieve 5-star rating for each transaction.
If you are not 100% satisfied, PLEASE do not leave a neutral or negative feedback but contact us by eBay message or email first so that we can help you.
Postage
Payment