Stop scrounging the junkyard for those hard to find Ford pinion yokes. Whether you’re rebuilding a stock unit for your favorite old Ford, or putting the final touches on that “bullet-proof” Ford 9-inch third member build, start fresh and save time with a new Speedway Motors Forged Short Pinion Yoke.
We replicated the original “short” 4-inch length yoke found on many late model Ford cars and trucks and updated it using modern forged carbon steel. Whether you’re restoring a vintage 1950’s-80’s Ford or Mercury to OEM specs or hooking up that ground-pounding, high-horsepower custom build – our forged pinion yoke can handle it.
This yoke will fit any Ford 9-inch with a 28-spline, 1.218” diameter pinion gear, and uses common 1310 series U-joints (). Machined relief cut provides for simple, bolt-on installation when used with an OEM standard or our Daytona-style pinion support () on your Ford 9-inch third member assembly.
Step up to a modern, easy-to-install and durable solution for your Ford 9-inch rebuild by choosing a Forged Pinion Yoke from Speedway Motors.
- Re-creation of the original Ford 9-inch “short” pinion yoke
- Made out of forged carbon steel for strength and durability
- Modern forged steel offers far more value than a junkyard yoke
- Machined relief cut to clear standard and Daytona pinion supports
- Fits all 28 spline 1.218” Ford 9-inch pinion gears
- Uses common 1310 series U-joints
- Thickness of ear where u-bolts go through is .818" or 13/16"
- Depth from face to bottom of u-joint cap recess is .520 or 1/2" plus
- Space between ears where u-joint caps fit is 3.211" or 3-3/16" plus
- Overall length is 4"
- Outside diameter at seal area is 1.813"
- Center to center of u-bolt holes is 1.415"
This pinion yoke is an OEM replacement for the following year/make/models listed:
- 1966-86 Bronco
- 1964-77 Comet
- 1967-79 Cougar
- 1968-83 E-100 1/2 ton
- 1979-88 E-150 1/2 ton
- 1968-74 E-200 3/4 ton
- 1957-83 F100
- 1968-87 F150
- 1957-71 Fairlane
- 1960-70 Falcon
- 1959-74 Galaxy
- 1975-79 Granada
- 1975-80 Grand Marquis
- 1965-79 LTD
- 1968-71 Mark III
- 1970-78 Maverick
- 1965-73 Mustang
- 1957-79 Ranchero
- 1955-79 Thunderbird
- 1968-76 Torino/ Grand Torino
We recommend that this yoke be installed with a pinion spacer and shim kit () and a new pinion nut () torqued to 175 ft lbs.
yes iwould
Summary: works great
Yes, I recommend this product.
Parts were great!
Summary: Product was just what was required.
Yes, I recommend this product.
i would buy this product again
Summary: good product and as described
Yes, I recommend this product.
Great price and quality part
Summary: I used this on a 73 torino 28 spine rear diff that is going into an old pick up. perfect fit.
Yes, I recommend this product.
I will not need to buy this product again, It is great.
Summary: Rebuilding a 9" Ford rear assembly and wanted to the yoke with shield. It is new, clean and fit perfectly.
Yes, I recommend this product.
