SOLID COPPER BELT RIVET & BURR

Available in a range of sizes and lengths and types 

Please use the drop down menu to order the correct size and length .

The bigger the number of the rivet , the smaller the rivet will be.

The # 12 rivet & burr is much smaller than the # 6

The length is measured from the outside edge of the flat head to the end of the post .

Remember , these rivets are designed to have the burr (washer) forced down the post so the material is compressed a bit, then the excess is cut off and the post is penned over the burr (washer).

The proper setter for the belt rivets is a forged steel setting tool that has a hole or two that allow the washer to be forced down the post. On the end of the tool it also has a dish shaped recess that acts to round over the post .

The quantity you will receive in each pack (unit) of the size you order is listed below. Most of the rivets are packed in a qty. of 12 (1 dozen). The # 6 has 6 rivets in each pack and the # 5 has just a pair (2). All rivets will have a burr (washer) included unless noted otherwise.

# 12 ...all lengths ... 12 rivets and 12 burrs

 # 10 ...all lengths ... 12 rivets and 12 burrs

 # 9 ...all lengths ... 12 rivets and 12 burrs

# 8 ...all lengths ... 12 rivets and 12 burrs

# 7 ...all lengths ... 12 rivets and 12 burrs

# 6 ...all lengths ... 6 rivets and 6 burrs

# 5 ...Round head 3/4" ... 2 rivets and 2 burrs

Stout 1/2" ...... 6 rivets / no burrs

Long round head ..... 10 rivets / no burrs

PLEASE INQUIRE ON FINISHES AND QUANTITIES

Thank you for looking at our listings