Brand New Peugeot Sport Group N 2" Exhaust

Stainless Steel Performance Exhaust System made in the UK

Decat centre pipe with dummy cat silencer and 2" tailpipe

Peugeot 106 XSi - GTi - RALLYE

Specifications are:

> 2" stainless steel bore

> 2" rolled out tail pipe

> 2 piece system

> decat centre pipe with dummy cat

> includes fitting kit

It was originally developed by Peugeot Sport UK for the "106 Super Cup" championship using 106 GTi's prepared to Group N specification. It was originally built for Peugeot Sport by Magnex, but it is now built by Scorpion Exhausts Ltd in the UK.

It is a 2 piece stainless steel system featuring a long centre pipe with a dummy cat and a single exit back box available in 2" or 3" tail pipe in our ebay store. It replaces the complete standard exhaust from the downpipe back.

Please be aware this is a de-cat exhaust which replaces the standard cat pipe on your car, so you will not pass your MOT with this exhaust fitted.

It is a competition exhaust so obviously very loud! It burbles at low revs but when revving hard the exhaust makes a distinctive "raspy" noise but not like a typical aftermarket "boomy" noise. The exhaust will pop and splutter when coming on and off the throttle due to its competition development. Very difficult to describe the noise in words, but the Peugeot Sport exhaust note is very well known in the Peugeot world!

The exhaust is very lightweight compared to the standard system so immediately you will have reduced the weight of your car if you fit the Peugeot Sport System.  The Peugeot Sport centre pipe weighs 3kgs, and the back box weighs 5kgs. This is significantly less than the standard exhaust which weighs over 15kgs.

 

This exhaust system gives excellent power gains. Independent tests have shown power increases of around 7bhp over the standard exhaust. See dynograph below:

The Peugeot Sport exhaust system was originally designed for the Peugeot 106 Series 2 GTi & Rallye, however it will fit the 106 Series 1 XSi and 1.3 Rallye models thanks to the extra brackets on the back box. It will fit most 106 models including the ones below. The decat centre pipe silencer has no hole for the lambda sensor, so if your model needs a lambda position here you need to fit a lambda sleeve or go for the motorsport cat centre pipe which has 2 lambda sensor holes in the silencer.

A free fitting kit is included which contains front joint bolts & gasket, middle and rear rubbers!