The jaws are a direct replacement for the originals.
The jaws are designed and printed by me here in the UK.
The jaw faces have three small vertical vee grooves and one small horizontal vee groove to assist holding small components.
Jaws will be supplied in either grey or black (depending upon current setup).
By default these jaws will be supplied with counter sunk holes (vee bottomed), should you require a counterbored holes (flat bottomed) option please see my other listings or message me.
I also sell the same jaws in pairs should you require them, please see https://www.ebay.co.uk/itm/265130195391
The vice shown is not included in bid - bid is only for a set of 3 soft jaws.
This listing is for shipping to Australia USA and Canada only - for UK shipping please see separate listings
Shipping time is listed by Royal Mail as 5-7 working days (no tracking - can be supplied at additional cost if required).
The material used for the jaws has a typical hardness as below;
- Hardness Shore D 59-77 (please see hardness comparison table attached to images).
I also offer the same jaws in aluminium (please see https://www.ebay.co.uk/itm/265429969750) and also have listed pairs/ sets of 3 of Extra soft jaws which are made from polyurethane (TPU) which are softer (Hardness Shore A 95 (approx)) - please see my other listings for details (https://www.ebay.co.uk/itm/265054829174).
The polyurethane/ PLA jaws are unsuitable for hot items as the plastic will melt (recommend max temp of 80C).
I can supply similar jaws to fit almost any vice size, please message me with details of your requirement (dimensions required - please see listings picture showing dimensions required).
Special face profiles can be custom supplied if required.
Please contact me for any questions/ special requirements and I will do my best to help.