eBay

Welcome to Larry's Small Engines.
There is a model list way down below but read this first.
This is for the TORO / Time Cutter / Exmarks and tractors butGo by Your part number to make sure You are getting the right one. This is PART No.# 139-0685, 1390685
THERE ARE TWO VERY IMPORTANT MESSAGES BELOW!!!
OTHER BUSINESSES WILL NOT TELL YOU THIS BUT IF YOU READ THE WHOLE DESCRIPTION BELOW, IT WILL TELL YOU THE REASON WHY YOU ARE MORE THAN LIKELY REPLACING YOUR FUEL PUMP WITH A NEW OE FUEL PUMP.IT WILL ALSO TELL YOU IF YOU EVEN NEED ONE OR NOT!
READ THE 5 MINUTE DESCRIPTION BELOW TO SEE WHAT OTHER BUSINESSES WILL NOT TELL YOU TO DO LIKE...
(1.) ON HOW TO SAVE MONEY AND MAKE YOUR FUEL PUMP LAST 2 TO 3 TIMES LONGER
(2.) WHY YOU SHOULD ONLY BUY AN OE FUEL PUMP THAT IS COMPAITABLE AND
(3.) HOW TO TROUBLESHOOT YOUR PROBLEM FIRST BEFORE BUYING AN OE FUEL PUMP.

HERE IS THE (1.) THING YOU NEED TO MAKE SURE THAT YOU ARE NOT DOING...

OUR OE FUEL PUMP IS COMPAITABLE WITH UP TO 10% (E-10) OF ETHANOL BUT....IT IS BEST TO USE FUEL WITH NO ETHANOL IN IT!!
QUESTION: WANT TO DOUBLE OR MORE LIKE TRIPLE THE LIFE OF YOUR FUEL PUMP?ANSWER: THEN STOP USING FUEL WITH ANY ETHANOL IN IT!
THEY WILL NEVER TELL YOU THIS BUTETHANOL EATS AWAY AT THIN RUBBER AND THIN PLASTIC.YOUR SMALL ENGINE WAS NOT MADE TO HAVE THAT FUEL WITH ETHANOL RAN THRU IT.ALSO NOT MADE FOR THE FUEL PUMP TO HAVE IT RAN THRU IT!!!ETHANOL WILL EVENTUALLY START EATTING AWAY AT YOUR CARBURETOR COMPONETS AS WELL, LIKE THE NEEDLE SEAT AND BOWL GASKET!!!THERE ARE FUEL STATIONS OUT THERE THAT SELL GASOLINE WITH NO ETHANOL IN IT.SHELL FUEL STATIONS OF 91 OR 93 V-POWER OCTANE IS A GOOD PLACE TO START.THERE ARE OTHERS OUT THERE LIKE STANDARD OIL, AMACO AND CHEVRON FUEL STATIONS JUST TO NAME A FEW, AS WELL AS MANY OTHERS. LOOK AT THE PUMP HANDEL! IT SHOWS RIGHT ON THE HANDEL AS TO IF IT IS E-10, E-15, E-30 OR E-85. E-85 IS JUST WHAT IT MEANS! 85% ETHANOL!!!!YOUR FUEL PUMP WONT LAST BUT A COUPLE OF
MONTHS AT MOST IF YOU PUT THAT E-85 IN IT!!!

HERE IS THE NUMBER (2.) THING...
WATCH OUT FOR THE CHINA LOOK-A-LIKE FUEL PUMPS OUT THERE!
THEM DEFECTIVE FAKES WILL NOT WORK RIGHT AND I SERIOUSLY DO MEAN THAT MOST DO NOT EVEN WORK AT ALL STRAIGHT OUT OF THE PACKAGE!!!THEIR INTERNAL COMPONETS ARE NOT MADE RIGHT!
1. THE DIAPRAGM IS TOO SMALL AROUND! IT DOES NOT SIT INTO THE RESSESED AREA OF WHERE IT SHOULD SIT. THIS CAUSES IT TO BE TOO TIGHT! IF IT IS TOO TIGHT THEN IT (THE DIAPHRAGM) CANNOT FLUCTUATE BACK AND FORTH TO PUMP THE FUEL!
2. EVEN IF THEY DID ACIDENTLY MAKE THE DIAPHRAGM THE RIGHT CUPPED SIZE, IT STILL WOULD NOT WORK RIGHT BECAUSE THEY DID NOT MAKE THE BRASS BREATHER VENT WHERE IT WOULD ALLOW THE AIR FLOW TO MOVE BACK AND FORTH.HOW WILL THE DIAPHRAGM REALLY BE ALLOWED TO MOVE BACK AND FORTH IF IT IS JUST A BUNCH OF GOBBED UP BRASS WITH NO REAL OPEN CELL TYPE MEMBRANE TO IT. I SWEAR THAT SOME OF THEM PEOPLE OVER THERE, SHOULD NOT BE PUT IN CHARGE OF HANGING A PICTURE ON A WALL!
3. EVEN THE MATERIAL THAT THEY WERE TRYING TO USE,TO MAKE THE DIAPHRAGM WAS NOT MADE OF A THICK PIT LINER RUBBER. SOME OF THEM OVER THEIR, USED A HEAVY THICK WIRE COMPRESSION SPRING! IT CANNOT BE MADE THAT STIFF AT ALL OR OHERWISE THE AIR FLOW FROM THE (ACIDENTLY MADE RIGHT) BRASS WEEP WOULD SERVE NO REAL PURPOSE AT ALL!
IT IS AS IF THEM PEOPLE OVER THERE HAVE NO REALCONCEPT AT ALL OF WHAT THE ACTUAL FUNCTION IS OF A FUEL PUMP. IDIOTS IS WHAT THEY ARE!!! THE ONLY REAL THING THAT MOST OF THEM ARE DOING OVER THERE ISSHIPPING THEIR GARBAGE OVER HERE TO FILL OUR LANDFILLS!!!
WITH SOME OF THESE NOT WORKING CORRECTLY OR IF EVEN AT ALL, THEN IT WILL WEAR OUT YOUR STARTER MOTOR FASTER AND SHORTEN THE LIFE OF YOUR BATTERY!
THIS IS WHY YOU SHOULD STICK WITH ONLY BUYING THE OE MADE FUEL PUMP!!!
LOOK CLOSELY AT THE PHOTOS OF THIS LISTING!
THAT FAKE FUEL PUMP THAT YOU SEE IN THE 4th, 5th,6th and 7th PHOTOS WAS FROM SOMEONE WHO BOUGHT / MADE A PRIOR PURCHASE ELSEWHERE AND THEN FOUND IT TO NOT WORK. THEY THEN MADE A PURCHASE FROM US AND TRIED TO DO A SWITCH-A-ROO RETURN OF THE FAKE ONE TO GET THE LARGER REFUND REFUND FROM US! LITTLE DID THEY KNOW THAT TO THE TRAINED EYE THERE IS A COUPLE OF TINY OUTSIDE DIFFERENCES OF THE OE PUMP FROM THE FAKE ONES.WE CANNOT SHOW WHAT THAT IS, OTHERWISE THEY WILL THEN TRY TO MAKE THAT LITTLE CORRECTION IN THE FUTURE, IN WHICH IT WOULD BE EVEN MORE DIFFICULT FOR US WITHOUT HAVING TO TAKE IT APART TO SEE.
AS FOR THEM, THEY WERE REPORTED, THERE WAS NO REFUND GIVEN AND THEY WERE THEN BLOCKED FROM EVER TRYING TO MAKE ANY FUTURE PURCHASES FROM US AGAIN!
THE BOTTOM-LINE IS...
HAS CHINA MADE ANYTHING AT ALL TO LAST OR TO REALLY BENIFIT ANY OF US HERE IN THE USA? THE ONLY REAL CONTRIBUTION THEY HAVE EVER MADE TO OUR COUNTRY IS THEFILLING OF OUR LANDFILLS WITH THEIR JUNK THAT THEY MAKE!!!YOU CAN BLAME OUR POLITICIANS FOR THAT CRAP!!!
THE OE FUEL PUMP!
The OE Fuel Pump is made of a Poly Resin Fiber (Not Cheap Plastic).It has a thicker (Not thin) pit liner diaphragm in it.The valves is made of rubber and not plastic either!This can also be carefully taken apart and cleaned if needed.This also comes with tiny rubber caps over the Fuel Inlet, Fuel Outlet and Vacuum Port to keep insects from getting inside and ruining the diaphragm during storage.
This is just another preventative measure so you know that you will receive a worry-free OE fuel pump straight out of the box.

The best installation procedure!
This should always be assembled in this order on just about everything...CLEAR PVC fuel line from tank to sediment bowl, to good quality fuel filter, to fuel pump and then to carb.
If You have a sediment bowl, then you should use it!!!

If it is at all possible (on anything that your engine is on) then mount a sediment bowl, anywhere after the fuel tank where You can visibly see it because this will help catch that unwanted water that seems to always find its way into your gasoline can. This is mostly caused from the fuel stations not removing the condensation soon enough from their tanks that are in the ground!A sediment bowl will keep the water from getting into your carburetor, filter and pump. This is because water is heavier than gasoline and you will see it in the sediment glass bowl. it is very simple to unscrew the glass from the sediment shut off valve, empty it and reassemble it.
Hopefully You found this info. (that others wont take the time to tell You) Helpful.

BELOW IS A FRACTION OF THE FEEDBACK RECEIVED.

Wish I would have bought this one first! Excellent price, quality, delivery...TY!!!............Buyer: ptcruizerman (484)
Fast shipping and great product. This was my 3rd fuel pump I purchased to get it running correctly. I specifically bought here for the quality, more expensive than the cheap garbage I got the First 2 times, but less than the wasted money for those 2 that did not work........................................................Buyer: ch493904 (2)
Better than expected Thanks..............................................................................................................Buyer: machos0 (223)

delighted with the fuel pump, nice kit that facilitates the installation. thanks!..........................Buyer:
scottyrunner (556)

EXCELLENT! SHOWED UNPRECEDENTED FOLLOWUP. Will buy here again...........................................................Buyer: curtholmes (841)Thank you very much! Perfect! Item as described, fast shipping........................Buyer: furryhans (324)Great price and product! fast shipping! 5star ebayer*****..........................................Buyer: cjs0058 (274)

You will receive an OE Fuel pump Just Like the One in the 2nd picture.

Before this fuel pump is shipped, it is removed from the box and

tested to make sure it fully functional.

We Guarantee Our fuel pump to be fully functional orYOUR FULL money back including FREE return shipping!
NO ONE SHIPS FASTER THAN US!
WE TRY TO SHIP SAME DAY IF ORDER IS COMPLETED BEFORE 11:00am EST. MON-FRI. BUTNO LATER THAN NEXT BUSINESS DAY.
Specs:
Fits 1/4" Fuel LineVacuum Pulse Pump. AGAIN, not compatible with more than 10% of ETHANOL but try to use fuel with NO ETHANOL in it for longer lasting life!
Here is just a small list of the models that use this Fuel pump.

23522 (Brush Cutter)

33522 (Brush Cutter)

74388 (TimeCutter ZS 3200S Riding Mower)

74616 (TimeCutter SS 4216 Riding Mower)

74621 (TimeCutter SS 3200 Riding Mower)

74629 (TimeCutter SS 3216 Riding Mower)

74650 (TimeCutter ZS 3200S Riding Mower)

74655 (TimeCutter ZS 4200S Riding Mower)

74665 (TimeCutter ZS 4200S Riding Mower)

74670 (TimeCutter SW 3200 Riding Mower)

74682 (TimeCutter ZS 3200S Riding Mower)

74684 (TimeCutter ZS 4200S Riding Mower)

74685 (TimeCutter ZS 4200S Riding Mower)

74705 (TimeCutter SS 4200 Riding Mower)

74710 (TimeCutter SS 3225 Riding Mower)

74710TA (TimeCutter SS 3225 Riding Mower)

74711 (TimeCutter SS 4200 Riding Mower)

74720 (TimeCutter SS 4200 Riding Mower)

74725 (TimeCutter SS 4200 Riding Mower)

74750 (TimeCutter MX 3450 Riding Mower)

74765 (TimeCutter MX 4200 Riding Mower)

74780 (TimeCutter SW 3200 Riding Mower)

74781 (TimeCutter SW 3200 Riding Mower)

75740 (TimeCutter 4200 Riding Mower)

Fits Exmark models

Exmark Lazer Z 60" Kohler Command 25hp

QTE452CEM42100 Quest Drive Levers

QTE452CEM42200 Quest Drive Levers

QTS452CEM34200 Quest Drive Levers

QZE452CEM42100 Quest Drive Levers

LARRY'S SMALL ENGINES.