Master Grade replacement Disk You bid 3 pairs of sharpening wheel, currently only available in Coarse, Medium and Fine wheel, please choose what grit do you want from the drop down to select the grit or combination grit. Thanks.
Compatible with Master Grade Commercial Sharpener or Master Grade Outdoor Sharpener Visit My eBay Store Available in Coarse, Medium & Fine New replacement disks/wheels Sold in a pair It bundled/ comes with whole cushion/ not only sleeve for safety reasons/1st Grade Quality
Stock# | Usage | Function | FS-300C coarse wheel | 2,000 ~ 2,500 passes | For re-profiling or to repair knives with chip(s) up to ?". | FS-302M Medium wheel | 1,500 ~ 1,800 passes | For heavy commercial use or speed sharpening. | FS-304F Fine wheel | 1,000 ~ 1,200 passes | To get razor sharp. Not for Pre-sharpening (re-profiling). |
IMPORTANT Read before you use the knife sharpener!!! Q: What causes the sharpening wheels to rip? A: 1. Dirty knives that have food particles or liquid. Make sure they are clean and dry. 2. If your knife has a chip(s) (up to ⅛”) you need to use the coarse sharpening wheels to remove chips, and sharpen with light pressure then increase the pressure slightly. Even the tiny chips (sometimes invisible from your eyes) or knife tip bent may rip the wheel. If the knife tip is bent, straighten it before sharpening. 3. If you allow the knife to vibrate it can damage the wheel. Hold your knife firm and glide it smoothly through each slot following the curvature of the blade. 4. Not using the correct grade of sharpening wheel. 5. Gouging the wheel with the knife heel by rushing the blade through the guide. 6. Not following the blade curvature when drawing the blade back through the guide. 7. If the sharpening wheel is bent, this problem may occur in connection with storage. Do not place heavy items on top of the sharpening wheel boxes. Q: If a wheel rips and is replaced and the wheel rips again what should I do? A: Insert the knife in sharpening slot then turning on the machine and push down with moderate pressure then turn off the machine. Move knife’s blade to the next inch (sharpening 1 inch at the time) than repeat it another inch up to the tip of the knife. After finishing one side of blade then repeat it in the opposite slot for the other side of blade. Once all chips have been removed, then do regular sharpening.
***If you want to sharpen the ceramic knife, please see our listing on Diamond Wheel****
freight cost to other countries please ask for quote (Flat rate box can accomodate 9 pairs of wheels-it will be the most economical for you to ship) Authenticity, Originality, Quality guaranteed! Quality and the best value always! Last but not least don't forget to Thank you and have a nice day :)
| 
