600ML 0.8mm Nozzle 220V Electric Spray Gun PG 350 Paint Spray Gun For Industry Car Auto Parts

Description:

• Voltage: 220v

• Frequency: 50Hz

• Jet flow: 0.26 l / min

• Working current: 0.6A

• Power: 75W

• Capacity: 600ML

• Frequency ratio: 50 hz

• Working pressure: > = 0.8mpa

• Working current: 0.4 ~ 0.6A

Usage:

• It is suitable for automobile parts, switchboard, control panel, heavy machinery, home appliance parts, steel furniture, woodworking products, gold plating protection, knitted fabric (fabric), garment dyeing and printing industry, suit, screen printing, mold, hardware , Advertising, IC version of the industry's most perfect decontamination tools, and so on!

• Use the operation:

• The liquid bottle filled with liquid. Connected to the 220V power supply, press the switch, 2, such as after the start does not work properly, then try the back of the knob, the method is: first spin the knob and then slowly swipe to achieve the minimum sound, the highest pressure so far. Hand at 50cm from the nozzle at the test pressure, with a strong Ma Zhen. (Note: tune well, usually do not just to adjust)

• Decontamination effective distance between the nozzle and the object 10-15cm, according to 45 degrees under the angle of operation, repeated spray to remove stains so far.

Maintenance:

• Guns can continue to operate, but also need to pay attention to moderate, so as to avoid overheating damage.

• The sound is normal but no jet, or spray powerless, loose is the nozzle block, unscrew the nozzle, clean up the debris, or with a fine needle from inside to outside gently twist through.

• The injection is normal, but the pressure is insufficient or unstable, you can open the handle cover, check the pump tight gong wire is loose.

• After the completion of the operation, need to spray a few seconds, the pump liquid spray finished, and then from the oil hole into the oil a few drops and then spray a few seconds.

• The gun is a high-pressure impact gun, must not spray on the human body. Should be placed in a child can not get the place.

• Can spray the paint: the basic flow of liquid can be sprayed on the consistency of certain requirements, accessories have a funnel, funnel filled, 50 seconds to finish the time that the paint can be sprayed, No need to dilute, (the gun is designed for the spray paint, so do not doubt, spray paint is absolutely feasible, but also the effect is very good)

• After each work is completed, must be in the tank with thinner (such as banana water), spray with a few times a few times, the tank and the nozzle of the residual paint spray clean. So the next use, the gun nozzle will not be blocked.