Brand new direct replacement stator

Connector and back plate included

Highest grade copper windings, resistant to 200 degrees Celsius

All products shipped are tested

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Connector included
• Back Plate included
• All product shipped are tested

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Sea-doo 580 GT -- 1990-1991
Sea-doo 580 SP -- 1989-1991
Sea-doo 580 XP -- 1991

290995102
290995105
420995105

Dimensions :
Interior diameter : 40 mm
Exterior diameter : 110 mm
Thickness : 32 mm
Length of wires stator to plug : 220 mm

Other specifications :
Number of wires : 6
Number of plugs : 1
Number of pins : 6

Wire to wire resistance :
Alternator :Yellow to Yellow = 0.9 ohms +-20%
Source 1 : Black/Red to White/Red = 4 ohms +-20%
Source 2 : Black to Black/red = 140 ohms +-20%

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".