Voltage Regulator for Yamaha 250 Timberwolf Bear Tracker 350 Wolverine Warrior Big Bear 400 Kodiak 600 Grizzly 1995-2001

KEY FEATURES
 

Brand new voltage regulator rectifier direct replacement

Improved heat sink and charging capabilities

Higher grade of electric components

All products shipped are tested

DESCRIPTION

 

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new aftermarket voltage regulator rectifier

  • Direct replacement to your original unit.
  • Plug-and-play, direct fit, easy installation.
  • No assembly required
  • Higher grade of electric components.
  • Improved heat sink and charging capabilities
  • The quality exceeds the OEM equipment
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Yamaha YFB 250 Timberwolf -- 1997-2000
Yamaha YFM 250 Bear Tracker -- 1999-2000
Yamaha YFM 250 Bear Tracker California -- 1999-2000
Yamaha YFM 350 Big Bear 2x4 -- 1996-1999
Yamaha YFM 350 Big Bear 4x4 -- 1997-1999
Yamaha YFM 350 Big Bear SE 4x4 -- 1997
Yamaha YFM 350 Warrior -- 1996-2001
Yamaha YFM 350 Warrior California -- 1998-2001
Yamaha YFM 350 Warrior Maine/NH -- 1996-1997
Yamaha YFM 350 Wolverine -- 1995-2001
Yamaha YFM 350 Wolverine California -- 1999-2000
Yamaha YFM 350 Wolverine Maine/NH -- 1995-1997
Yamaha YFM 400 Big Bear -- 2000-2001
Yamaha YFM 400 Kodiak -- 1996-1999
Yamaha YFM 600 Grizzly -- 1998

OEM part replacement

 

4KB-81960-00-00
4KB-81960-01-00
4KB-81960-02-00

Specifications

 

Dimensions :
Width : 50mm
Length : 75mm
Height: 25mm
Fixation holes center to center : 60mm
Wires length: 200mm

Other specifications :
Number of plugs : 1
Number of pins : 5

instructions

 

Before installing your new regulator/rectifier:

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.