Generator Stator for Yamaha XV 700 Virago XV 750 Virago XV 1100 Virago 1986-1999

KEY FEATURES
 

Brand new generator stator

You must re-install your original grommet and the new connector (see picture).

All products shipped are tested.

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part

DESCRIPTION

 

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new stator

  • You must re-install your original grommet and the new connector (see picture).
  • Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Connector included
  • All product shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Vehicle models fitment

 

Yamaha Virago XV 1100 -- 1986-1999
Yamaha Virago XV 700 -- 1986-1987
Yamaha Virago XV 750 -- 1988-1997

OEM part replacement

 

1RM-81410-20-00
1TA-81410-20-00
4PP-81410-00-00

Specifications

 

Dimensions :
Interior diameter : 53 mm
Exterior diameter : 114 mm
Thickness : 17 mm
Length of wires stator : 700 mm

Other specifications :
Number of wires : 4
Number of pins : 4

Wire to wire resistance :
Alternator : White between each White = 0.4 ohms +/-20%

instructions

 

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".