Brand new stator direct replacement

Highest grade lamination materials

Highest grade copper windings resistant to 200 degrees celsius

All products shipped are tested

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Connector included
• All products shipped are tested

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Arctic Cat Powder 700 Special Carb L/C -- 1999-2000
Arctic Cat ZL 700 Carb L/C -- 2000
Arctic Cat ZR 700 Carb L/C -- 1999-2000

3005-522

Dimensions:
Interior diameter: 47mm
Exterior diameter: 115mm
Thickness: 20mm
Length of wires stator to plug: 21mm

Other specifications:
Number of wires: 8
Number of plugs: 2
Number of pins: 8

Wire to wire resistance:
Alternator: = 0.4ohms +/-20%
Source: 18ohms =+/-20%

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010??.