Mosfet Regulator for Piaggio Beverly / MP3 250 400 500 | X9 500 | X8 / X-Evo 250 400 2001-2013 | OEM# 639110 / 58086R

KEY FEATURES
 

Brand new aftermarket Mosfet voltage regulator rectifier

Plug-and-play, direct fit, easy installation

Higher grade of electric components

All item pictures are accurate

All products shipped are tested

DESCRIPTION

 

Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Why use Mosfet Enhanced technology?



Runs cooler

Runs much cooler than the traditional Shunt voltage regulator rectifier.


Saves gas

Less load on the stator, less work, less fuel is used and you save.


Regulated energy

The power charging your battery is steadier and smooth.

 


Extended battery life

Extends the battery’s life and cold cranking capacity.


More engine power

Removes stator load resulting in more engine power.


Optimized power

Optimize power delivery by switching the stator coils on or off.

RMSTATOR Enhanced technology=


With enhanced technologydesign

This product is an advanced design that lowers operating temperatures for extended longevity and better performance than the OEM part.

Brand new Mosfet Voltage Regulator Rectifier

STOP BURNING YOUR REGULATOR RECTIFIER !
It is time to update or replace your voltage regulator with the advanced MOSFET type.
It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.
  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • The quality exceeds the OEM equipment
  • Improved heat sink and charging capabilities
  • Higher grade of electric components
  • All shipped products are tested

*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Piaggio Beverly 250 -- 2006-2008
Piaggio Beverly 400 -- 2006-2008
Piaggio Beverly 500 -- 2002-2008
Piaggio Carnaby 250 -- 2008
Piaggio MP3 250 -- 2006-2011
Piaggio MP3 400 -- 2007-2011
Piaggio MP3 500 -- 2008-2013
Piaggio X7 250 -- 2008
Piaggio X8 250 -- 2005-2007
Piaggio X8 400 -- 2006-2007
Piaggio X9 500 -- 2001-2009
Piaggio X-Evo 250 -- 2007-2008
Piaggio X-Evo 400 -- 2007-2008

OEM part replacement

 

58086R
584533
639110
344006000
JC32800X94000
02602400
774477

Specifications

 

Dimensions:
Width: 108 mm
Length: 84 mm
Height: 41 mm
Wires length: 355 mm & 945 mm
Fixation holes center to center: 81 mm

Other specifications:
Number of plugs: 2
Number of wires: 7
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20? to 85?

instructions

 

Before installing your new Mosfet Voltage Regulator Rectifier :

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors