Voltage Regulator Rectifier for Yamaha XT 600 1984-1989

KEY FEATURES
 

Brand new aftermarket voltage regulator rectifier

Direct replacement to your original unit

Higher grade of electric components

Plug-and-play, direct fit, easy installation

All products shipped are tested

DESCRIPTION

 

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new aftermarket voltage regulator rectifier

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • No assembly required
  • Higher grade of electric components
  • The quality exceeds the OEM equipment
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Yamaha XT 600 -- 1984-1989

OEM part replacement

 

34L-81960-A0-00

Specifications

 

Dimensions:
Width: 69 mm
Length: 59 mm
Height: 25 mm
Wires length: 235 mm (2 pins) & 180 mm (3 pins)
Fixation holes center to center: 55 mm

Other specifications:
Number of plugs: 2
Number of pins: 5
Number of wires: 5
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20? to 85?

instructions

 

Before installing your new voltage regulator rectifier:

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors