Voltage Regulator for Kymco Downtown 125 200 300 | Movie 125 150 | People / Xciting 250 500 | Yager / Dink 200 2005-2015

KEY FEATURES
 

Brand new aftermarket voltage regulator rectifier

Direct replacement to your original unit. Plug-and-play, direct fit, easy installation

Higher grade of electric components

All products shipped are tested

DESCRIPTION

 

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new aftermarket voltage regulator rectifier

  • Direct replacement to your original unit.
  • Plug-and-play, direct fit, easy installation.
  • No assembly required
  • Higher grade of electric components.
  • The quality exceeds the OEM equipment
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted corroded defective and a major cause for repetitive electrical issues.

All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Kymco Dink 200 -- 2006-2013
Kymco Downtown 125 -- 2009-2014
Kymco Downtown 200 -- 2011-2015
Kymco Downtown 300 -- 2009-2015
Kymco Movie 125 S -- 2007-2010
Kymco Movie 150 S -- 2007-2010
Kymco People GTi 300 -- 2010-2014
Kymco People S 250 -- 2007-2009
Kymco People S 300 -- 2008-2012
Kymco Xciting 250 -- 2006-2014
Kymco Xciting 300 -- 2008-2014
Kymco Xciting 500 -- 2005-2014
Kymco Yager GT 200 -- 2009-2014

OEM part replacement

 

31600-LDG7-900
31600-KED9-900
31600-KED9-E10

Specifications

 

Dimensions:
Width: 76 mm
Length: 106 mm
Height: 17 mm
Wires length: 191 mm & 165 mm
Fixation holes center to center: 61 mm

Other specifications:
Number of plugs: 2
Number of pins: 5
Number of wires: 5
Minimum Charging Voltage: 14.5V +- 0.5V
Maximum Charging Current: 50A/500W
Open Circuit Voltage: 15V
Operation Temperature: -20? to 85?

instructions

 

Before installing your new voltage regulator rectifier:

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator rectifier.
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.