Brand new aftermarket stator

Direct replacement to your original unit. Plug-and-play, direct fit, easy installation.

Highest grade copper windings, resistant to 200 degrees Celsius.

All products shipped are tested

Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Please note : There are 2 possible stators for Ducati Multistrada 2003-2006. This stator has an inner diameter of 42 mm, an outside diameter of 104 mm and a stack height of 36 mm. The other stator possible for this model is RMS010-104750.

Please compare your original unit to our pictures, before buying.

Brand new aftermarket stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Connector included
• Rubber grommet included
• All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Ducati 748 Biposto -- 1998-1999, 2002
Ducati 748 S -- 2002
Ducati 996 Biposto -- 2001
Ducati 996 Super Bike -- 2000-2001
Ducati 996R -- 2001
Ducati 998 -- 2002-2004
Ducati 998R -- 2002
Ducati 998S -- 2002-2004
Ducati HyperMotard 1100 -- 2007-2009, 2011-2012
Ducati HyperMotard 796 -- 2010-2011
Ducati MH 900 E -- 2001-2002
Ducati Monster 1000 -- 2003-2005
Ducati Monster 1100 -- 2009
Ducati Monster 600 -- 2000-2001
Ducati Monster 620 -- 2002-2006
Ducati Monster 695 -- 2007-2008
Ducati Monster 696 -- 2008-2012
Ducati Monster 750 -- 1998-2000, 2002
Ducati Monster 796 -- 2010-2011
Ducati Monster 800 -- 2003-2004
Ducati Monster 900 -- 1998-2002
Ducati Monster S2R 1000 -- 2005-2008
Ducati Monster S2R 800 -- 2005-2007
Ducati Monster S4R 1000 -- 2006-2008
Ducati Monster S4RS 1000 -- 2006-2008
Ducati Multistrada 1000 -- 2002-2006
Ducati Multistrada 1100 -- 2007-2009
Ducati Multistrada 620 -- 2005-2006
Ducati Sport 620 -- 2003
Ducati Sport 750 -- 2002
Ducati Sport 800 -- 2003
Ducati Sport 900 -- 2002
Ducati SportClassic GT 1000 -- 2006-2008
Ducati SportClassic Sport 1000 -- 2005-2009
Ducati Superbike 748 -- 1998, 2000-2003
Ducati SuperSport 1000 -- 2003-2006
Ducati SuperSport 620 -- 2003
Ducati SuperSport 750 -- 1998-2002
Ducati SuperSport 800 -- 2003-2007
Ducati SuperSport 900 -- 1998-2002

26420471A
264.4.014.2B
264.4.014.3B
264.4.022.1A

Dimensions :
Interior diameter : 42 mm
Exterior diameter : 104 mm
Thickness : 36 mm
Length of wires stator to grommet : 152 mm
Length of wires grommet to plug : 609 mm

Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3

Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +-20%

Before installing your new stator

• Check the AC output of the stator
• Replace any burned or corroded connectors on stator and regulatorrectifier
• Check and repair any melted wiring
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".