Brand new high output stator + voltage regulator rectifier + PeakRPM CDI box + flywheel puller + flywheel + external ignition coil kit
The quality exceeds OEM equipment
Direct replacement to your original unit
All item pictures are accurate
All product shipped are tested
*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
High output stator 200 wattsRMSTATOR is offering a new replacement flywheel with stronger magnets for your YAMAHA YFZ350 BANSHEE, this flywheel can be used as a direct replacement to the OEM.
Flywheel pullerYamaha YFZ 350 Banshee -- 1987-1994
RM23008
High output stator
Number of wires : 6
Number of terminals : 6
Alternator : Yellow to Black = 0.4 ohms+/-20%
Pick up 1 : White/Green to White/Red = 115 ohms+/-20%
Source 1 : Green to Red = 12 ohms+/-20%
High performance CDI box
The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.
External ignition coil
Bracket center to Bracket: 90mm
Improved flywheel
Diameter of fly wheel- 130mm
Flywheel puller
27 MM x 1.0 Left hand male
Before installing your new stator
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
CDI Box HP
Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.
Improved Flywheel
Before attempting to start your banshee adjusting the air gap is necessary.
Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".
External ignition coil
Remove the yellow wire from the external ignition coil, if it is not applicable to your model.
find parts for :