Fits:

Features:

Easy Installation

High flow design provides long lasting, efficient cooling
Factory lubricated for long life
Precision ground shaft and hub accept fan clutches perfectly
Quality forged housing is specially formed to ensure maximum coolant flow
Precision built and balanced - Pressed on impeller increases water flow
Unitized seal protects bearings - Provides long life and leak free performance

The Radiator cooling fan is an integral part of your car that is responsible for cooling the Radiator of your car. The Radiator cooling fan does this by either pulling or pushing air into the Radiator keeping the Radiator temperatures within the safe levels. A damaged Radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a Radiator cooling fan.

Note:

It is recommended to replace your Radiator Fan Clutch & Water Pump at the same time. The two parts age at the same rate so if one has failed, the other is probably not far behind. The fan clutch and water pump are also connected by the same shaft. When one part fails it typically affects the operation of the other. To prevent premature failure of your new unit, it is wise to replace both at the same time.

Radiator Notes:

Specification:

Core Material: Aluminum

Tank Material: Plastic

Quantity: 1pcs Radiator

Warranty:1 Year limited

Direct Replacement

100% brand new Radiator (as picture showed)

--------------------------------------------

? Installation guidelines provided in the box

? Premium OE hardware and fittings included in every box

? OE design to ensure exact fit, form and function for an easy drop-in installation

? Maximum cooling efficiency and perfect fit

? Leak-tested aftermarket Radiator

? SO 9001 certified manufacturing plants

How to replace a new Radiator?

1. Disconnect the battery.

2. Drain the Radiator fluid into a suitable container.

3. Remove the old Radiator:

-Take off any plastic covers around the Radiator.

-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.

-Disconnect the Radiator hoses from the Radiator.

-Disconnect the transmission cooling lines from the bottom of the Radiator.

-Remove any clamps, brackets, or screws holding the Radiator inside its frame.

-Lift the Radiator up and out of the car.

4. Install the new Radiator:

-Slide the new Radiator into place.

-Connect any clamps or brackets that hold the Radiator in place.

-Connect the transmission cooling lines carefully.

-Connect the engine cooling hoses to the Radiator.

-Replace the fan and fan shroud.

-Reconnect the fan electrical connection.

-Replace the plastic covers.

5. Fill the Radiator with fluid.

6. Check your work to make sure that there are no leaks.

(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)

Note:Do please keep children and pets away when replacing the Radiator)

-----------------------------------------------------------------------------

Attention:

? project operation, the vehicle normal temperature 60 to 80 degrees.

? add detergent if the tank is too full can take some antifreeze.

Information About AC Condenser

1.Such condensers typically also use a fan to force air through the heat sink and away from the tropics. Refrigeration principle of the general refrigerator The function of the compressor is to compress the steam with lower pressure into steam with higher pressure, so that the volume of the steam is reduced and the pressure is increased.

2.The compressor draws in the lower pressure working fluid vapor from the evaporator, causes the pressure to rise, and then sends it to the condenser, which is condensed into a higher pressure liquid in the condenser, and is throttled after the throttling valve becomes a pressure. After the low liquid is sent to the evaporator, it absorbs heat in the evaporator and evaporates to become a lower pressure steam, thereby completing the refrigeration cycle.