Straight steel panhard bar, 26-1/2" eye-to-eye. With 3/4" heims.
Note: When using these bars, your specific application my require the use of heim spacers for maximum range of motion. Spacing out the mounting tabs prevents the heim joint body from making contact with the them. This provides for greater misalignment (range of motion) without decreasing hole size.
If your application requires the use of misalignment spacers then 910-07000 would be the best one for you. It is 1/2” thick and when you use one on each side of the heim they will add a total of 1” of thickness. 910-07001 could also be used if you need to space out further from your mounting point as it is 1” thick.
This kit includes:
- Steel Sleeve for 3/4" heims
- 3/4" LH male standard heim
- 3/4" RH male standard heim
- 3/4" LH raw jam nut
- 3/4" RH raw jam nut
I shortened this bar to fit my needs
Summary: Used this for panhard bar when I cut down my 9" ford rearend to put in my 70 C10
Yes, I recommend this product.
I would buy this again
Summary: Good Universal Pinard bar
Pros: Big 3/4 hind joints
Worked great!
Summary: Used in my 1964 IH c1300. Worked awesome!
Yes, I recommend this product.
Easy peasy!!
Summary: I loved the product overall I had to customize the bar but I knew I would have to being a custom rear end.
Yes, I recommend this product.
Very heavy build. 3/4" heims, 1/2" not if you need them
Summary: This makes a fantastic panhard bar! Check out the "lower shock bracket" Speedway has too(in the picture). Is cheaper than the weld on kit, much heavier and adjustable and CHEAPER!
Yes, I recommend this product.
