Brand new aftermarket stator
Plug-and-play unit, direct fit, easy to install.
Highest grade of copper winding, resistant to 200 degrees Celsius
Direct replacement to your original unit
All products shipped are tested
If the OEM original stator has 2 prongs, the RM01099 is the compatible one
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Our 15 years experience advise to:
Before purchasing our replacement stator please compare the picture from our add to your original part.
With these older sleds sometimes the motor or part has been swapped out, the best way to make sure is visually.
*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
Ski-doo Alpine 508 Carb F/C -- 1990
Ski-doo Alpine II 503 Carb F/C -- 1987-1990
Ski-doo Citation 250 Carb F/C -- 1987-1989
Ski-doo Escapade 503 Carb F/C -- 1987
Ski-doo Formula MX 467 Carb L/C -- 1987-1989
Ski-doo Formula Plus 521 Carb L/C -- 1989
Ski-doo Formula Plus 537 Carb L/C -- 1987-1989
Ski-doo Nordik 50 Carb F/C -- 1988-1990
Ski-doo Nordik 60 Carb F/C -- 1988-1990
Ski-doo Safari 250 Citation Carb F/C -- 1989-1990
Ski-doo Safari 377 Carb F/C -- 1987-1988
Ski-doo Safari 377 E Carb F/C -- 1987-1988
Ski-doo Safari 377 F Carb F/C -- 1987-1988
Ski-doo Safari 377 Saga Carb F/C -- 1989
Ski-doo Safari 377 Scout Carb F/C -- 1989-1990
Ski-doo Safari 377 Scout E Carb F/C -- 1989
Ski-doo Safari 503 Carb F/C -- 1988
Ski-doo Safari 503 Cheyenne Carb F/C -- 1989-1990
Ski-doo Safari 503 Escapade Carb F/C -- 1989
Ski-doo Safari 503 R Carb F/C -- 1988
Ski-doo Safari 503 Voyager Carb F/C -- 1989
Ski-doo Skandic 377 R F/C -- 1987
Ski-doo Skandic 503 Carb F/C -- 1987
Ski-doo Skandic 503 R Carb F/C -- 1987
Ski-doo Stratos 503 Carb F/C -- 1987
Ski-doo Tundra 250 Carb F/C -- 1987-1990
410912500
Dimensions :
Interior diameter : 43 mm
Exterior diameter : 108 mm
Thickness : 18 mm
Length of wires : 200 mm
Wire to wire resistance :
Alternator : Yellow To Yellow/Brown = 0.4 ohms +/-20%
Source : Black to Black/Red = 78 ohms +/-20%
Before installing your new stator
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
find parts for :