3 x In-Line XLR Attenuator -20dB (600ohm)

This listing is for three (3) attenuator only, front and rear views shown. Multiple quantities can be purchased if required.

How it works - If you experience problems trying to finely tune the volume on your amplifier, the chances are that the input into your amplifier is too high. The symptom is relatively easy to spot as you will notice that the volume is loud enough when the dial on your amplifier is in the 9 o'clock position, but is too loud when the dial has reached the 10 o'clock position. It is therefore almost impossible to finely control the volume. 

This problem is otherwise known as 'excess gain' (which causes your sound to be too high at lower settings). Our XLR attenuator uses precision resistors to reduce the excess.

How to use - The XLR attenuator should be plugged into the input on your integrated amp or pre/power amp. Depending on which decibel attenuator you have chosen, (the more excess gain the higher the decibel needed), the volume range on the dial will be increased from two to five hours from where it was before, i.e. broadening the previous range (9 to 10 o'clock) to 9 - 2 o'clock, thus giving greater control over the volume.

Designed specifically for high end systems with excess gain. 

Decibel (dB) is a logarithmic unit of measurement that expresses the magnitude of a physical quantity, usually power or intensity. We offer the XLR attenuator in -10dB, -15dB and -20dB