Regulator for Yamaha Snoscoot ES 2018 2019 2020 2021 2022 OEM Repl. # 8ML-H1960-00-00

KEY FEATURES
 

Brand new aftermarket Voltage Regulator Rectifier

Direct replacement to your original unit

Higher grade of electric components

The quality exceeds the OEM equipment

All products shipped are tested

DESCRIPTION

 

Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Brand new aftermarket Mosfet voltage regulator rectifier

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • No assembly required
  • Higher grade of electric components
  • Improved heat sink and charging capabilities
  • The quality exceeds the OEM equipment
  • All products shipped are tested
  • We have even included the opposite connector (main harness side) as we know these are often melted corroded defective and a major cause for repetitive electrical issues.

    All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part

    Vehicle models fitment

     

    Yamaha Snoscoot 200 -- 2018
    Yamaha Snoscoot 200 ES -- 2019-2022

    OEM part replacement

     

    8ML-H1960-00-00
    0630-349

    Specifications

     

    Dimensions:
    Width: 55 mm
    Length: 81 mm
    Height: 22 mm
    Wires length: 140 mm
    Distance between fixation holes center to center: 65 mm

    Other specifications:
    Number of plugs: 1
    Number of pins: 3
    Number of wires: 3
    Minimum Charging Voltage: 14.5 V +- 0.5 V
    Maximum Charging Current: 50 A / 500 W
    Open Circuit Voltage: < 15 V
    Operation Temperature: -20?C to 85?C

    instructions

     

    Before installing your new Voltage Regulator Rectifier:

    • Check the AC output of the stator
    • Replace any burned or corroded connectors on stator and regulator rectifier
    • Check and repair any melted wiring
    • Use hi-temp dielectric grease on all connectors