Control Relay Relay 30 AMP, 12 Volt Coil AIM99LS Digital, & 9169 Digital with BARTLETT CONTROLLER, DOES *NOT* WORK FOR KILNS WITH FUJI CONTROLLERS This relay fits the Digital Kilns that run on 220V/240 volts. There are usually 2 or more of these relays in the larger kilns. These relays cycle and off during the firing. Relays have a life in the 300,000 click range. If one bank of coils does not heat or stays on, then a new relay is needed. If a relay fails on, switch the kiln off at the breaker and unplug the kiln. Do not run the kiln again until the relay has been changed. It takes all the relays working together for the kiln to work properly. Check your kiln to make sure of fitment. You may have more than one installed. |