Brand new aftermarket Ignition Source Coil to repair your stator
Often unavailable from the OEM manufacturer
Highest grade of lamination materials and copper winding, resistant to 200 degrees Celsius
Works with all other OEM parts
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
Yamaha Big Wheel BW80 -- 1986-1988, 1990
Yamaha Y-Zinger PW80 -- 1983-1985, 1991-2003
21W-85512-21-00
1RY-85512-20-00
Dimensions:
Bar Coil Length: 50 mm
Thickness: 13.75 mm
Wires Length: 110 mm and 450 mm
Other specifications:
Number of wires: 2
Number of pins: 2
Wire to wire resistance:
Source: Black to Red/Black = 223 ohms +-20%
Black Wire is Grounded to Core
Step 1 : Take the ignition cover off. Are the remplacement parts similar? Compare the replacement part to the original. The remplacement part should match, including the mounting hole locations, If not: Double check the application listing with your bike.
Step 2 :Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.
Step 3: Remove the flywheel using a proper puller tool.
Step 4: Remove the baseplate with the original coil.
Step 5: Remove the screws that secure the coil and take the coil off.
Step 6: Cut the original wire close to the original coil. Take a good look at how the wire is connected to the coil. Connections: Connect the old wire up to the new coil. Use a soldering iron and resin core solder. (the type used in electrical applications
Step 7: Mount the coil onto the baseplate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY!
Step 8: Refit the stator baseplate. Ensure the wires CAN NOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel)
Step 9: Refit the flywheel. Tighten the bolt to specified torque.
Step 10: Fit the ignition cover.
Engine will not start: Sometimes the source coil wires are reversed. Swap the connections, re-solder the wires and the engine should start. If the engine still does not start, and before calling technical support, performs a few basic tests:
If you still cannot get the engine to start, have all your testing information ready for a technician prior calling.
find parts for :