Stator Pick-Up Pulsar Coil for Yamaha Venture Lite Phazer 500 |RS Venture Vector Rage Viking / Nytro 1000 2003-2018

KEY FEATURES
 

Brand new aftermarket pick-up coil for Stator 200 ohms

Often unavailable from the OEM manufacturer

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

All products shipped are tested

DESCRIPTION

 

Brand new pick up coil for Stator 200 ohms

  • We offer a brand new pickup/pulsar coil for you to repair your stator.
  • Often unavailable from the OEM manufacturer
  • All products shipped are tested

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Vehicle models fitment

 

Yamaha Nytro 1000 -- 2006-2007
Yamaha Nytro 1000 ER -- 2006-2007
Yamaha Phazer 500 -- 2007-2018
Yamaha RS Rage 1000 -- 2005-2007
Yamaha RS Vector 1000 -- 2005-2009
Yamaha RS Venture 1000 -- 2005-2018
Yamaha RS Venture 1000 GT -- 2007-2009
Yamaha RS Viking 1000 Professional -- 2008-2015
Yamaha RX Warrior 1000 -- 2004-2005
Yamaha RX-1 -- 2003-2005
Yamaha SRX 700 -- 2000-2002
Yamaha SX Viper 700 -- 2002-2003
Yamaha SX Viper 700 ER -- 2002-2004
Yamaha SX Viper 700 Mountain -- 2003-2006
Yamaha SX Viper 700 S -- 2004
Yamaha Venture 700 -- 2004
Yamaha Venture Lite 500 -- 2007-2013, 2015-2018
Yamaha Venture MP 500 -- 2013-2017
Yamaha Viking 1000 Professional -- 2006-2007

OEM part replacement

 

8FA-81410-00-00
8ES-81410-01-00
8ES-81410-00-00
8GC-81410-10-00
8GC-81410-00-00
1XD-81410-00-00
5B4-81410-00-00
8EK-81410-10-00
8EK-81410-01-00
8EK-81410-00-00
8DN-81410-00-00

Specifications

 

Dimensions:
Height: 20 mm
Length: 20 mm
Width: 20 mm
Bracket center to center: 35 mm
Wires length : 750 mm

Other specifications:
Number of wires : 2
Number of pins: 2

Wire to wire resistance:
Black to White = 200 ohms +/-20%

instructions

 

Not following these instructions may result in damaging the part or other components on your vehicle.

  • By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
  • Insulate your solders with heat shrink.
  • Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
  • Rotate the flywheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010".
  • If no spark or erratic spark, switch the wires at the plug.