HST-3000 CU Copper Testing Module

Test the Copper, Test the Service, Improve the Process

Equipped with the Copper Testing option and a copper Service Interface Module , the HST-3000 can quickly troubleshoot the local loop for line impairments that degrade or impair T1 performance. With the HST-3000, technicians can quickly identify and locate cable impairments: shorts, grounds, opens, crosses, bridged taps, wet sections and other high resistive faults. These impairments are easy to access with the HST-3000's advanced time domain reflectometer (TDR), precision digital volt/ohm meter (DVOM) and an accurate resistive fault locator (RFL) to pinpoint troubles prior to circuit installation. Copper test features are optimized for use anywhere on the local loop at the NID, cross box, pedestal, main distribution frame or anywhere a technician might gain access to the local loop to locate the source of trouble.

Test the Copper Test the Triple Play

• DVOM
• TDR
• Balance
• Loads
• Opens Complete copper testing to support triple-play deployments
• Expanded copper testing frequency range
  • Tx/Rx Tones ranging from 100 kHz to 30 MHz
  • Wideband Noise measurements from +15 to -90 dBm
  • Impulse Noise measurements from +15 to -60 dBm
  • Spectral analysis with spectral masks and band plans up to 30 MHz (-28 to -150 dBm/Hz)