Each is Tested and pulled for a fully working Wii board as ordered.
Each wire is Factory in Place.
Each is for a certain corner by Wire Length.
These are Marked A or B as pictured.
One A and B have wires still attached to them as pictured.
The Other A and/or B not with attached wires would be for the other side of the board.
I have a few of these.
Many resolders are needed to replace this board.
The Last photo shows the wire sequence for each solder spot.
It is the same for each input.
Nothing else included but for reference ONLY.
These 4 are heavy over 1 lb so cost is higher.
Contact me directly if you just need one exact corner or more other then all 4.