This is a kit with the minimum required items to rebuild a CTIS wheel valve for the FMTV's. Kit is enough for one wheel valve. The diaphragm, inlet air filter, and a pair of new banjo bolt seal washers are included as pictured. I recently updated the kit to include a new valve stem cover and valve stem, both Haltek, nickel plated. Noticed that the valve stem cores in some of the rebuilds I was doing were gummed up from oil & RTV. Spicer used valve stem cores that had long, rubber backings on them in a lot of wheel valves but it is not necessary. Haltek made those valve stem cores for wheels with balance beads in them so they would not get wedged in the valve stem. The only reason why I can see Spicer used them was to make sure you did not put the core in too deeply.

I have a separate listing for an o-ring kit for all the hoses on the wheel valve assembly.

I finally found a reliable and steady source for all of these parts so I will try to continually keep these in stock moving forward. I may improve upon this kit in the future as well.