This MIDI Thru box is the special 2 input 10 output splitter which I designed from scratch which is not available in the market.

Please see my store items and review Youtube video. youtube.com/watch?v=HIda10k1Uxs

With ten MIDI output ports you set per port which input it comes from. So, effectively it can be two domain independent splitter with any other combination 1x5+1x5 or 1x2+1x8 and so on. This gives lots of flexibility to the routing, as you may have to MIDI input devices such as a keyboard and DAW output that you can map to the required port without messing with cables. This switch doesn't support merging of input 1 and 2, its either of those at a time.

There are two options for switches - micro slide type of the switch or a jumper. Jumpers are for more hardwired environment there you need the robust option that you can't move by a mistake. While slide switch option is for flexibility to choose MIDI input port. Leave a note if you need slide switches or jumpers.

It has optimized schematics for 5V and 3.3V MIDI sender devices, optimized circuitry for optocoupler to minimize false triggering and improve sensitivity. Finally it uses hex inverter with a Schmitt trigger for driving a stronger output signal. This makes it very reliable device.

This is a DIY kit for soldering.

Assembling info and BOM at: github.com/Deftaudio/Midi-boards 

Beginner soldering skills required. That means you have to understand schematics, not just being able to solder two wires together. There are no high expectations, but being able to read schematics and understand polarity of components are quite important.

Board size and an enclosure choice: Size: 6x27cm

Some of you wondered ideas for enclosure selection. Well, some kits produced here can be installed into cast cases, such as MidiThru-4 or MidiMerge_2in->5out into 1032L enclosure. It requires drilling and some patience. Other boards are just too big to go into typical aluminum case. I found it much easier to put them in between two acrylic panels cut to the size and connect them with plastic standoffs. I typically use M3 standoff 20mm and 5mm. 20mm goes on top, and has enough room to cover DIN5 sockets, while 5mm goes on the bottom. There is CorelDraw file on Github with precise board dimension and holes location.


Shipping:

Item will be shipped by Air Mail on the Same or Next Business day of receiving full payment.
This is international shipping from US. Exact delivery time varies from your location and could be up to 3-5 weeks.

NOTE: Don't be surprised, USPS has increased the shipping cost since Jan 01 2016, so the minimal package costs $19.50 for the first class international.