Brand new kit digital multimeter + voltage peak reading DVA adapter
The quality exceeds OEM equipment
All item pictures are accurate
If in doubt do not hesitate to compare our item to your original part
All products shipped are tested
All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
Digital Multimeter:Here at RMSTATOR our goal is to get our customers running again, sometimes that includes long conversations over phone and email troubleshooting their problems.
Often our customers are only equipped with a common multimeter, this is a good start but useless as you cannot read peak voltage output.
Stators may fail in various ways, Most common is the windings shorting to ground either directly or to the coil that interfaces with the ignition. But there are other ways. Coils can short internally which gives good resistance but essentially fewer windings giving low voltage output.
The other way a good stator can not provide power is if the rotating magnets in the flywheel are dead.
We finally have come out with the tool that you can simply attach to your multimeter and will allow you to test peak voltage with your common multimeter.
N/A
Digital Multimeter:
Maximum Voltage (terminals to ground): 600V
Fuse Protection: 200mA/250V
Wires length: 700mm
Voltage Peak Rading Adaptor:
Install peak volt reading adapter to positive and negative leads of the multimeter. Be sure to put your meter on the DC volts scale in order to get proper readings.
find parts for :